SITE INFORMATION AND CORRESPONDENCE

Home Browse Search

EGEG ROTRON ROTRON REGENERATIVE BLOWERS INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS,FOR SL SERIES AND DR SERIES BLOWERS 11 EXCESS AIR --- Bleed excess air off. DO NOT throttle to reduce flow. When bleeding off excess air, the blower draws less power and runs cooler. 2] BOLT IT DOWN — Any blower must be secured against movement prior to starting or testing, to prevent injury or damage. 31 WIRING — Blowers must be wired and protected/fused in accordance with local and national electrical codes. All integral-motor blowers must be grounded to prevent electrical shock. -` 41 PIPING — All blowers (except SL series) should be piped, muffled, and/or filtered prior to starting. Care must be taken so that no foreign material enters the blower. If foreign material does enter the blower, it could cause internal damage or may exit at extremely high velocity. 51 SUPPORT THE PIPING —The blower flanges and nozzles are designed as connection points only, and are not designed to be support members. 6] PRESSURE/SUCTION MAXIMUMS —The maximum pressure and/or suction listed on the model label should not be exceeded. This can be monitored by means of a pressure or suction gage (available from Rotron), installed in the piping at the blower outlet or inlet. Also, if problems do arise, the Rotron Application Engineering staff will need to know the operating pressure/suction, to properly diagnose the problem. 7] REMOTE DRIVE (MOTORLESS) BLOWERS— Properly designed and installed guards should be used on all belts, pulleys, couplings,etc. Due to the range of uses,drive guards are the responsibility of the customer or user. CAUTION: Plastic piping should not be used on blowers larger than 1 HP that are operating near their maximum pressure or suction point. Blower housing and nearby piping temperatures can exceed 200 degrees Fahrenheit. Access �jerste onnel to the housing or nearby piping should be limited, guarded, or marked, to prevent danger of burns.