Laserfiche WebLink
Table 5 <br /> Groundwater Analytical Data-Fuel Oxygenates and VOCs <br /> South Shore Parcels-Parcel 2A and Adjacent Areas <br /> West Weber Avenue and North Lincoln Street <br /> Stockton,California <br /> sec- Iso- p-Iso- 4-Iso- 1,2,4-Tri- 1,3,5-Tri- <br /> Methylene n-Butyl- tert-Butyl- Butyl- propyl- propyl- propyl- Naph- Propyl- n-Propyl- methyl- methyl- Other <br /> Sample Date MtBE TBA DIPE EtBE TAME Methanol Ethanol chloride TCE 1,2-DCA Acetone benzene benzene benzene benzene toluene toluene thalene benzene benzene benzene benzene Chloroform VOCs` <br /> ID Sampled (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) (mg/1) <br /> Explanations: <br /> 1,1,2-TCA=1,1,2-Trichloroethane TBA=Tertiary Butyl Alcohol <br /> 1,1,2,2-TCA=1,1,2,2-Tetrachloroethane TCE=Trichloroethene <br /> DCA=Dichloroethane U=Upper groundwater zone <br /> DIPE=Di-Isopropyl Ether VC=Vinyl Chloride <br /> EtBE=Ethyl tertiary Butyl Ether VOCs=Volatile Organic Compounds <br /> FD=Field Duplicate <=Below given laboratory detection limit <br /> Freon 11 =Trichlorofluoromethane ---=Not Analyzed <br /> L=Lower groundwater zone '=Other unspecified VOCs were tabulated in Treadwell&Rollo's Volume ll,Site Characterization Report dated 12/13/99. <br /> mg/I=milligrams per liter <br /> MtBE=Methyl tertiary Butyl Ether <br /> ND=Not detected;laboratory detection limit unspecified in historical tables <br /> TAME=Tertiary Amyl Methyl Ether <br /> 1 =The method reporting limit(MRL)was raised,due to the presence of an interfering compound. 38=Carbon Tetrachloride detected at 1.5 ug/L. <br /> 2=The method reporting limit for Chloromethane was raised,due to the presence of an interfering compound. 39=The method reporting limit for 1,2-Dichloroethane has been increased due to the presence of an interfering compound. <br /> 3=The method reporting limit for 1,2,3-Trichloropropane was raised,due to the presence of an interfering compound. 40=The method reporting limit for methanol has been increased due to the presence of an interfering compound. <br /> 4=The method reporting limit for 1,2,3-Trichlorobenzene was raised,due to the presence of an interfering compound. 41 =Chloromethane detected at 0.76 ug/L. <br /> 5=The method reporting limit for 1,1,2-Trichloroethane was raised,due to the presence of an interfering compound. 42=Bromoform detected at 0.51 ug/L. <br /> 6=The method reporting limit for 1,1,2,2-Tetrachloroethane was raised,due to the presence of an interfering compound. 43=Vinyl Chloride detected at 0.60 ug/L. <br /> 7=Samples were collected by Clayton Group Services for Unocal:Lincoln/Weber. 44=Chloromethane detected at 0.95 ug/L. <br /> 8=The method reporting limit for 1,2,4-Trichlorobenzene was raised,due to the presence of an interfering compound. 45=Chloromethane detected at 0.87 ug/L. <br /> 9=The method reporting limit for 2,2-Dichloropropane was raised,due to the presence of an interfering compound. 46=Chloromethane detected at 0.85 ug/L. <br /> 10=The Matrix Spike/Matrix Spike Duplicate Results were affected by the analyte concentration already present in the un-spiked sample. 47=The MRL for 1,2-Dibromo-3-chloropropane has benn increased due to the presence of an interfering compound. <br /> 11 =Blank Analyzed 02/19/04. 48=Repeat analysis by Modified Method EPA 8015 yielded inconsistent results. The concentrations appear to vary. <br /> 12=The method reporting limit for Bromodichloromethane was raised,due to the presence of an interfering compound. 49=Matrix Spike/Matrix Spike Duplicate results for Chlorobenzene were outside of control limits. This may indicate a bias <br /> 13=Samples were analyzed by EPA Method 8260B using a bottle that contained a headspace bubble greater than 1/4-inch in diameter. for the sample that was spiked. <br /> 14=Bromodichloromethane detected at.0031 ug/L. 50=Matrix Spike/Matrix Spike Duplicate results were outside of control limits. This may indicate a bias for the sample that was spiked. <br /> 15=Bromodichloromethane detected at.0026 ug/L. 51=Matrix Spike/Matrix Spike Duplicate results were affected by the analyte concentrations already present in the un-spiked sample. <br /> 16=Bromodichloromethane detected at 1.3 ug/L. 52=Wallace-Kuhl did not sample due to ongoing negotiations with the City and the Regional Board. <br /> 17=1,4-Dichlorobenzene was detected at 0.00059 ug/L. 53=Bromodichloromethane at 1.2 ug/L. <br /> 18=Sample was re-analyzed to confirm the presence of compounds that were detected in the first analysis. 54=Wells destroyed in November 2008 as part of the Unocal excavation activities by Treadwell and Rollo. <br /> 19=Samples were collected by Wallace Kuhl for Unocal:Lincoln/Weber. 55=The method reporting limit for Bromodichloromethane was raised,due to the presence of an interfering compound. <br /> 20=The method reporting limit for Styrene was raised,due to the presence of an interfering compound. 56=The method reporting limit for Chloromethane, 1,1,2-TCA and 1,1,2,2-Tetrachloroethane was raised,due to the presence of an interfering compound. <br /> 21 =1,4-Dichlorobenzene detected at 1.2 ug/L. <br /> 22=Styrene detected at 2.9 ug/L. <br /> 23=1,1,2-Trichloroethane detected at 2.7 ug/L. <br /> 24=Bromodichloromethane detected at 0.70 ug/L. <br /> 25=Chloroform detected at 8.6 ug/L,Bromodichloromethane detected at 7.0 ug/L <br /> 26=Bromodichloromethane detected at 0.00097 mg/I <br /> 27=The method reporting limit for TCE was raised,due to the presence of an interfering compound. <br /> 28=The method reporting limit for DIPE was raised,due to the presence of an interfering compound. <br /> 29=The method reporting limit for 1,3,5-Tri methyl benzene was raised,due to the presence of an interfering compound <br /> 30=Matrix Spike/Matrix Spike Duplicate results were outside of control limits.This may indicate a bias for the sample that was spiked. <br /> Since the LCS recoveries were within control limits,no data are flagged. <br /> 31=The MRL for 1,2-Dichloropropane has been increased due to the presence of an interfering compound. <br /> 32=The method reporting limit for DIPE was raised due to the presence of an interfering compound. <br /> 33=Ethanol detected at 11 ug/L. <br /> 34=The method reporting limit for Naphthalene was raised,due to the presence of an interfering compound. <br /> 35=The method reporting limit for 2+4-Chlorotoluene was raised,due to the presence of an interfering compound. <br /> 36=The method reporting limit for Ethanol is increased due to the presence of an interfering compound. <br /> 37=Carbon Tetrachloride detected at 0.72 ug/L. <br /> Stantec <br /> I:\Tidewater\TW Stockton(Parcel 2A-0415)\Tables\QMR Tables\2010\4Q10\20101117-Parcel2A(Tables 4,5,6,7)Historical GW Tables 4Q10.xls Page 45 of 45 <br />