Laserfiche WebLink
A Prel2aring the Fitting & FRP wall <br /> A.1) Prepare your fittings by identifying the parts. Clean the surfaces of all fittings with <br /> trichloroethylene or acetone to remove any contamination. Hand sand with 60-grit sandpaper if <br /> necessary. Do not lay them on dirt, water, debris or other contaminated surfaces. When dusting off, <br /> use a shop brush, chip brush or compressed air. Do not use rags, cloth or cloth-like material <br /> ` DRY-FIT YOUR FITTINGS TO BE SURE THAT THEY ALIGN <br /> PROPERLY. <br /> CRITICAL DO NOT PLAN HOLE SAW CUTS ON UNEVEN SURFACES. <br /> FLAT PANELS ONLY. CAREFUL OF CORNERS AND EDGES. <br /> I ' A YOU CAN NOT MOUNT FITTINGS ON ROUND SURFACES. <br /> A.2) Dust off Sump walls (inside and out) and drill your pilot holes centered on the planned fitting <br /> locations using a 1/4" Drill bit. Proceed when done to cut your holes with 2-1/2" size hole saw with <br /> 1/4" centralizer. Hand-sand the rough edges inside and outside made by the hole saw. <br /> AN 2 5 2018 <br /> CRITICA&, ,I,in-nrlfA,, -& _rA F-,�3LTH <br /> ALL SUMPS AND BRAVO SYSTEMS FIBERGLASS F-SERIES <br /> FITTINGS MUST BE KEPT FREE OF CONTAMINANTS, <br /> ESPECIALLY DIRT AND WATER OR MOISTURE. <br /> APPLY MEASURES TO KEEP THE INSTALLED FITTINGS DRY <br /> WHEN LEFT OVERNIGHT ON-SITE. <br /> HOLE SAW SIZE CHART ` <br /> 2-1 /2 for F-17-XX, F-10-XX �,-- <br /> f. <br /> l <br /> Fig. A3 <br /> A.3) RECOMMENDED: Use the Sanding kit (Page 4, sanding ; <br /> gun sold seperately) to lightly abrade each hole until the surfaces <br /> are flat and even and white fiberglass is open and visible.(Fig. A3). <br /> DO NOT OVERGRIND!! MAINTAIN A MINIMUM WALL THICKNESS OF 1/8" INCH. <br /> For other manufacturers, lightly grind off any gel-coat or gloss finish until flat. <br /> Replace any gel-coat or fiberglass that is removed in excess. <br /> Follow Manufacturers Installation Instructions. <br /> 5 ii-F-Series-1 X-SS-11 A <br />