Laserfiche WebLink
STEP D1) Get your injection syringes and your adhesive kits ready. See Page 4 or 9. <br /> The amount of adhesive shown on the Adhesive chart on page 8 must be measured and <br /> injected into EACH port on the fitting. Each fitting has two ports. One inside and one outside. <br /> STEP D2) Mix your approved adhesive kit with the provided fiberglass filler. Load your syringe <br /> by placing the tip in the can of mixed adhesive and drawing it up. PURGE THE AIR FROM THE <br /> SYRINGE TIP (Pg. 9) <br /> STEP D3) Quickly inject the adhesive into the Adhesive Injection Port, which is located at the top <br /> of each fitting body. The paste should flow into the interior channel and seep out along the conduit. <br /> (Fig. D3) <br /> DO NOT ATTEMPT TO INJECT BOTH SIDES AT ONCE <br /> INJECT INJECT <br /> ADHESIVE ADHESIVE <br /> OUTSIDE INSIDE <br /> F I RSTSECOND Adhesive <br /> Injection <br /> ' f complete <br /> Fig. D3 <br /> USE ONLY ROBROYTM PVC-COATED CONDUIT <br /> or any brand hot-dip galvanized conduit <br /> bead with bead with <br /> gloved finger gloved finger <br /> Outside of Sump Inside of Sump <br /> STEP D4) Run adhesive around the joints and bead with a gloved finger and let cure. (Fig D3) <br /> JAN 2 5 2018 <br /> 10 ii-F-Series-1 X-SS-11 A <br /> ENVIRONMENTAL HEALTH <br /> DEQ AI;T,MENT <br />