Laserfiche WebLink
r,p1,lI11CIA COAFY11C1'IWICIIIO Safety Data Sheet (SDS) <br /> ABCO Products of Sacramento <br /> Alumatte Etch <br /> SDS Number: 101 Revision Date: 12/26/2014 <br /> Page 5 of 9 <br /> Handle with care and avoid spillage on the floor. <br /> Keep material out of reach of children. <br /> Keep material away from incompatible materials. <br /> Do not use corrosive-sensitive materials for handling product. <br /> Wash thoroughly after handling. <br /> Ensure adequate ventilation. <br /> Storage Requirements: Keep away from heat,sparks and flames. <br /> Do not store in direct sunlight. <br /> Store away from strong acids,strong reducing agents,strong oxidizing agents,organic <br /> materials,water,chlorinated solvents,reactive metals(Zinc&Aluminum)and their alloys <br /> (Brass),Alkali metals(Lithium,Sodium,Potassium,etc.),Tin&Tin oxides, Lead, <br /> Phosphorous&Phosphorous Pentoxide,Nitro compounds(Nitromethane,etc.),Azides, <br /> Anhydrides and Halogens. <br /> EXPOSURE CONYROLS/PERSONAL PROTECTION <br /> Engineering Controls: All ventilation should be designed in accordance with OSHA standard(29 CFR 1910.94). Use <br /> local exhaust at filling zones and where leakage and dust formation Is probable. Use <br /> mechanical(general)ventilation for storage areas. Use appropriate ventilation as required to <br /> keep Exposure Limits in Air below TLV&PEL limits. <br /> Personal Protective Equip: Eye/face protection: <br /> When using material use safety glasses,gloves and apron according to HMIS PP,C. All <br /> safely equipment should be tested and approved under appropriate government standards <br /> such as NIOSH(US)or EN 166(EU). <br /> Skin protection: <br /> Handle with gloves made from Neoprene,Nitrile or Bums rubber. Gloves must be Inspected <br /> prior to use. Use proper glove removal technique(without touching glovers outer surface)to <br /> avoid skin contact. Dispose of contaminated gloves according to applicable laws and <br /> laboratory practices. <br /> Body Protection: <br /> Chemically resistant gloves,apron and safety glasses are recommended. Type of protective <br /> equipment should be selected based on concentration amount and conditions of use of this <br /> material. <br /> Respiratory protection: <br /> Full-face dusUvapor respirator may be required as backup to engineering controls when <br /> proper engineering controls are not In place to keep TLV and PEL limits below defined <br /> thresholds. <br /> Control of environmental exposure: <br /> Prevent leakage or spillage if safe to do so. Do not let material enter drains. <br /> Components with workplace control parameters: <br /> Component(s): Sodium Hydroxide,solid <br /> CAS No(s): 1310-73-2 <br /> USA OSHA Table Z-1 Limits for Air Contaminants(C): 2 mg1m3 <br /> USA OSHA Occupational Exposure Limits Table Z-1 Limits for Air Contaminant(TWA): 2 mg/m' <br /> USA ACGIH(CrrLV): 2 mg/m' <br /> USA ACGIH(CEIL/TLV): 2 mg/m' <br /> USA NIOSH Recommended Exposure Limits(C): 2 mg1m3 <br />