Laserfiche WebLink
Garrett Backus [EH] <br /> From: Garrett Backus [EH] <br /> Sent: Friday, August 09, 2013 11:21 AM <br /> To: 'Azevedo, Steve' <br /> Subject: RE: Hazardous Waste inspection report <br /> Steve, <br /> I noticed that the Generator Waste Profile Sheet is not signed and dated at the bottom by the generator(Knife <br /> River). The profile sheet should be completely filled out at the time the waste is hauled from your site. <br /> Thank you, <br /> Garrett Backus <br /> Senior Registered Environmental Health Specialist <br /> San Joaquin County Environmental Health Department <br /> 1868 E Hazelton Ave, Stockton, CA 95205 <br /> Phone: (209)468-2986 <br /> Fax: (209)468-3433 <br /> Email: gbackus@sicehd.com <br /> From: Azevedo, Steve [mailto:Steve.Azevedo(akniferiver.com] <br /> Sent: Friday, August 09, 2013 10:00 AM <br /> To: Garrett Backus [EH] <br /> Subject: RE: Hazardous Waste inspection report <br /> Dear Mr. Backus, <br /> Attached please find a signed Return to Compliance Certification. Steps we have taken to ensure compliance are as <br /> follows: <br /> • As discusses, apparently, a hazardous was determination had already been made based on generator <br /> knowledge and some analytical testing. Please see the attached Generator Waste Profile Sheet that was used <br /> for disposal of the waste generated by the power washing. In addition, the hazardous waste contractor <br /> (Advanced Chemical Transport) performs analytical testing on each batch of this type of waste that they send to <br /> the disposal facility. Each batch may consist of waste generated by and comingled from a number of <br /> generators. In the future,we are considering using a different waste disposal contractor that will perform the <br /> analytical testing solely on our waste and not a comingled waste. <br /> • We have contacted the used oil hauler and instructed them to use the current active EPA ID number going <br /> forward. In addition, we met with their driver to explain this and to affix the current EPA ID number onto the <br /> hazardous waste accumulation label. <br /> • As noted on your inspection report,the accumulation start date on the oily solids drum was corrected during <br /> the inspection. <br /> 1 <br />