ARCHIVED REPORTS_XR0004388 - Laserfiche WebLink

Home Browse Search

Page 7 Pressure transducer probes were placed in Monitoring Wells 1,2 and 3 and were hooked up to an Insitug Datalogger 2000. A probe was not placed in Monitoring Well 4 because Insitu informed us that the probe cable picked up signals from the Grunfos (brand) pump and tended to erase Datalogger 2000 settings and information during a pump test. Measurements for MW 4 were obtained manually using a Keck water level probe. The pump test was started at 415 p.m on October 15, 1991, and the pump was turned off at 11.00 a m. October 16, 1991, for a drawdown time of 18 hours and 45 minutes. Measurements of the recovery were taken for two hours after the pump was turned off Pumping rate during the test averaged approximately 215 gallons per minute. An attempt was made 16 hours into the test to increase the pump rate, but the pump began sucking air almost immediately, so the pump was returned to the 215 gallons per minute rate. Readings of the water level in each well were taken four times between 415 and 7.00 p m. and hourly thereafter until the pump was turned off at 11.00 a m After each round of readings, the pump flow rate was measured by placing the discharge water in a 1/2 gallon measuring container and timing the rate of fill. The manual probe readings are shown in the charts below Actual probe readings and charts generated by the Datalogger 2000 are included in the Appendix Monitoring Well #1 -28 9 -28 98 ■ ■*I■6 17 19 21 2 3 1 3 5 7 9 1 1 1 1 1 1 1 1 1 2 12 13 - 291 1 k 5 0 0 0 00 00 00 00 00 0 0 1 2 0 3 0 2w3 0 0 0 0 9 0 6 0 0 0 -29 02 ` 33 Depth from -29 04 Surface _29 06 -- ■� i-' .-■ -29 0 8 011.0-0-0 APP `■-■- APP. %-29 1 ■ ■ -29 12 _■i -29 1 4 The gap in readings from 11:00 to 11:26 is due to taking manual readings for Monitoring Well 4 Parker Environmental Services 4185 Rialto Court Pittsburg CA 94565-6116 Phone (510) 439-1024 Fax (510) 439-2566