Laserfiche WebLink
Page 10 <br /> • IX. HAZARD AMIGATION <br /> Identify procedures to mitigate all hazards listed in Section VIII by placing the task number next to <br /> the appropriate mitigating measure Listing of standard procedures is not inclusive. A specific <br /> procedure must be entered to mitigate each hazard identified in Section VIII. <br /> Activity <br /> List Number A. MECHANICAL HAZARDS <br /> I Do not stand near backhoe buckets, drill ngs and earth moving equipment <br /> 1.2 Verify that all equipment is in good condition <br /> 1 Do not stand or walk under elevated loads or ladders <br /> NE Do not stand near unguarded excavation or trenches. <br /> NE Do not enter excavation or trenches over 5 feet deep that are not properly <br /> guarded, shored, or sloped <br /> 1.2 Consult SSO if any other mechanical hazards exist <br /> B ELECTRICAL HAZARDS <br /> 1 Locate and mark buried utilities before drilling <br /> 1 Utilities located by on <br /> 1 Maintain at least 10 foot clearance from overhead power lines. <br /> 1 Contact utility company for minimum clearance from high voltage power <br /> lines <br /> 1 If unavoidably close to buried or overhead power lines, have power turned <br /> off, with circuit breaker locked and tagged. <br /> 1 Properly ground all electrical equipment <br /> 1 Avoid standing in or near water when operating electrical equipment <br /> 1 If equipment must be connected by splicing wires, make sure all <br /> connections are properly taped. <br /> 1 Be familiar with specific operating instructions for each piece of equipment. <br /> NE = NOT EXPECTED <br /> Parker Environmental Services, 4185 Rialto Court, Pittsburg, CA 94565-6116 <br /> Phone (510) 439-1024 Fax (510) 439-2566 <br />