WORK PLANS - Laserfiche WebLink

Home Browse Search

TABLE 3-1 DRILLING/PROBING PROCEDURES (First 5 feet below surface) Step 1 - Site Walk Conduct Site walk. Verify that the Checklist for Subsurface Clearance has been fully completed. Step 2 -Locate Locate all utility markouts and borehole locations. Start intrusive activities at least Markouts five 5)feet awayand perpendicular to all marked utilitylines. Step 3-Break Use a jackhammer or concrete saw to ba�o through the asphalt or concrete surface Surface Cover cover. The drill bit on the rig may also sed on the asphalt cover.Do NOT advance bit or cutting tools beyond the shalt or concrete cover. Step 4- Use air knife with vacuum extractors,hand auger, or hand shovel to remove soil from Surface Boring the borehole to a depth of at least 5 feet below surface.The soil in the borehole should be excavated to a diameter of at least three inches greater than the diameter of the drill bit on the lead auger or drill stem that is to be used. If it is not possible to perform a surface boring which meets the diameter requirements as stated above, surface borings should be installed to the required depth of 5 feet surrounding the proposed well/boring location in such a manner that any lines/utilities passing through the proposed well/boring location will be encountered while installing the investigation borings/well. If pea gravel, fill material, or refusal is encountered,and was not expected to be encountered,abandon the boring and follow instructions from item#9 of section 5.4.1. Step 5-Soil If soil samples are required to be collected within the first 5 feet below surface, a Sam lin hand auger should be utilized to collect native,undisturbed soil sam les. Step 6- If no piping or other structures are encountered within the first 5 feet below surface, Borehole normal drill/probe activities may proceed with caution. Containerize drill cuttings as Protection appropriate. If excavation of the borehole is conducted the day before actual drilling is conducted,the borehole should be covered with barricades or cones and with a sheet of material sufficient in strength to support a person's weight until it is ready to be drilled. If the borehole is of sufficient size to potentially cause damage to a vehicle if driven over,the borehole should be covered with a material sufficient in strength to support vehicular weight. In lieu of barricades or cones and a material cover,the boring may be temporarily backfilled to surface.If a backfill material is utilized,it is important for the material to be flush with the surrounding pavement. Risks of injury associated with the drilling operation itself also exist. The risks of working near overhead electrical lines may also present a safety hazard. The SSHO will check for the presence of overhead lines and other obstructions. No drilling operations will be performed within 10 feet of overhead lines with voltages 0-50 kV. For other voltages refer to ATC Electrical Safety Policy(No. 12)and Equipment(Drill Rigs,Mobile Equipment)Policy(No. 15). 20160613 Stockton,March Ln 2016 HASP 5-5 6/13/16)