WORK PLANS - Laserfiche WebLink

Home Browse Search

Environmental Multi-Task Job Hazard Analysis Page 1 of 5 JHA Type: Investigation _x_Well Drilling Pilot Testing Date: 3/14/2017 Site Construction x Soil Sampling_x_Groundwater Sampling Office: SFO Client: BTQCLC Location: 21801 Hwy 120, Escalon, CA Personal Protective Equipment(PPE): Minimum PPE is Level D including: safety glasses with fixed side shields, reflective Class II orange vest with an reflective X on the back, six-point suspension hard hat, safety-toed boots, hearing protection(as needed), and gloves(type dependent on job-specific requirements). Development Team Position/Title Reviewed By Position/Title Date Mike McLeod Geologist Job Steps: Utility Locates for Underground and Overhead Hazards Potential Hazard: • Energized Buried Utilities • Water Lines • Energized Overhead Utilities 0 Sewer Lines • Telecommunication /Fiber Optic Lines a Foundations • Oil/Gas Lines 0 Underground Tanks/Vessels Critical Actions: Operator of Equipment a Local Utility representative(s) may wish to be • Clear utilities prior all work. Confirm with Utility onsite when drilling/excavating near utility. The Locate Standard Operating Procedures located in site safety officer(SSO)will escort the utility the Appendix of the HASP. representative the entire time onsite. • Mark buried utilities with paint. • Ensure overhead clearances for rig masts and cables are within required limitations (10 feet for 50 KVA minimum; 15 feet recommended). Job Steps: Ground Work on Rough Surfaces Potential Hazard: • Slip-Trip-Falls Critical Actions: • Create exclusion (safe)work zones around drill rig or excavation machinery. Job Steps: Vehicle Traffic/Travel Potential Hazard: • Moving Vehicles and Equipment a Vehicle Traffic • Work Zone Road Hazards Critical Actions: • Avoid cell phone use while driving when possible. a Secure loads on vehicles. As necessary, cell phone may be used when driving . Avoid moving vehicle the confined areas (less if it is equipped with a "Hands Free Device." than 3 feet of clearance around vehicle)without a • No texting or emailing when driving. spotter. Remove keys from ignition and engage • Inspect vehicles and trailers before driving (tires, parking brake before leaving vehicle. lights, etc.). • Develop Traffic Safety Plan if needed and use as • Adjust mirrors (views for left, right, and rear). appropriate. • Fasten seatbelts before engaging vehicle. • Obey posted speed limits and traffic laws. Check trailer hitch connections and lights before operating if needed. Kennedy/Jenks Consultants Multi-Task Job Hazard Analysis September 2016 pAs-proj12003-post archivea30118.27 blgcic mw install and wdr amendmentlrnw instaIR04-harplenvironmental multi task jha.doc