ARCHIVED REPORTS_XR0012607 - Laserfiche WebLink

Home Browse Search

f M.. 3 NO C II1✓f.D PROCEDURES ------ •�"••�'" Site _Safety flan This plan describes the safety requirn rements for purging and sapling ground-water monitorifig wells. The site safety plan is applicable to personnel of Applied GeoSvstems who perform work at the site. A copy of the site safety plan is available for reference by appropriate parties during the work. The onsite Staff Geologist of Applied GeoSystems acts as the Site Safety Officer. round- later Sarnplmg The static water level in each well was measured to the nearest 0.01 foot with a Solinst electric water-level sounder cleaned with a laboratory-grade, non-phosphatic detergent and deionized water before use in each well. A clean bailer was used to obtain P.sample from the surface of the water in the well for subjective analysis of hydrocarbons. 'File sample was retrieved and visually examined for floating product, sheen, color, and clarity. Approximately 3 well volumes of ground water were purged from the wells using a stainless- steel electrical submersible pump. The pump, cables, and hoses were cleaned with a laboratory-grade, non-phospltatic detergent and water before use in each well. The wells were purged until withdrawal was of sufficient duration to result in stabilized pH, temperature, and electrical conductivity of the water, as measured by portable. meters calibrated to a standard buffer and conductivity standard, The wells recovered to more than 90 percent of the static water level within 5 minutes of turning off the pump. The ground water purged from the wells was temporarily stored in 17-E, steel, 55-gallon liquid waste drums approved for this use by the Department of Transportation. Before collecting each ground-water sample,the geologist cleaned the Teflon bailer with a laboratory-grade detergent and rinsed it with tap water and deionized water. Hydrochloric acid was added to the sample vials as a preservative. A sample of the formation water then was collected from the surface of the water in each of the wells with the Teflon bailer and slowly transferred to laboraiory-cleaned sample containers. Reporting Results of Analyses Hydrocarbon constituents in groundwater samples are reported by the laboratory in units of parts per billion (ppb). The maximum contaminant levels listed in Title 22 of the California Code of Regulations for benzene, ethylbenzene, and total xylene isomers in drinking water are 1-0,6$0,and 1,750 ppb, respectively. The action level established by the California Department of Health Services for toluene is 100 ppb. To confrrm with the laboratory reports, we report ground-water chemical data in units of ppb. 061 i rsis 35012-7