Laserfiche WebLink
p(' F <br /> 7 <br /> L <br /> worn to prevent cross <br /> latex gloves will be one pair of disposable <br /> contaminati <br /> sampling. les. <br /> on with other samples. <br /> gloves will be dedicated to each sample collect`d�inder will <br /> Once the sample is collected, each end to eheand ythen capped <br /> foil or tend nlabeled. The sample <br /> be sealed with aluminum foil <br /> taped, in a ziplock bag and <br /> with a polyethylene sealed ice or <br /> will then be individually dry <br /> laced in an ice cl1V5t containing Certified <br /> immediately P for delivery to a state and <br /> frozen chemical ice identification, storage <br /> laboratory' <br /> be conducted as Outlined in the previous <br /> transportation will <br /> section. <br /> 11.3 Sampling from Soil Piles or Shallow Soil Pits <br /> transported from <br /> samples will be collected and <br /> the manner described in the previous <br /> Soil If <br /> excavated material in not be utilized. <br /> section, however, a backhoe wilf four brass cylinders will <br /> composite samples are collected, <br /> 50 cubic yards of material to e <br /> P the lead regulatory <br /> be collected for every ecified by the state <br /> sampled unless otpless will <br /> be COMPO testing. <br /> by <br /> agency. The camp personnel prior to testing. <br /> certified analytical laboratory P <br /> 12,0 Groundwater Sampling Protocol <br /> Prior to arriving at the sampling site, <br /> all sampling <br /> washed with laboratory grade detergent, <br /> will be water, once with acetone, and once <br /> equipment be carried out <br /> and rinsed twice with to This procedure will wells, if more <br /> with deionized wateling of other monitoring Same sampling <br /> on-site before s�llvl is pto be sampled with the <br /> than one well <br /> device. DTW) in <br /> Immediately prior to sampling, the depth tc water duct on tOP <br /> will be recorded. The thickness will be measured using an <br /> 1 the well if present, is presented <br /> of the groundwater. <br /> interface probe. The procedure for Monitoring Protocol) - <br /> in Section 9.0 (Groundwater Monitoring <br /> product is detected, analysis of groundwater at the <br /> If free P product will not b? conducted. <br /> interface for dissolved p ecific <br /> Sample will be collected for source idrval scatlan. <br /> product P sample from <br /> I£ all free Product cannot be rem o dcollect t a P <br /> sampling device may be utilized at least <br /> the zone of free product. Before collecting lwill be <br /> below samples from each well, the <br /> two groundwater same parameters (temperature, conductivity <br /> purged until Inde. This will entail the removal of at least <br /> e The <br /> and Pkv) stabilize. vclumes by bailing or Pumping. <br /> four well casing well casing volumes and tomP(Well <br /> criteria far determining parameter measurements <br /> storage of purged water is outlined in Section 10-0, <br /> Development Protocol). The indicator P of each well <br /> will be taken bath before and after purging <br />