Laserfiche WebLink
sampling, latex gloves will be <br /> worn to prevent- cross <br /> contamination with other samples. One, pair of c]isp°sable <br /> gloves will be dedicated to each sample Collect ccyylinder will <br /> ollected, each end of the <br /> be sealed with aluminum foil or teflon tape and t <br /> hen capped <br /> Duce the sample is cThe sample <br /> with a polyethylene lid, taped, and labeled. <br /> will then be individually sealed in a zipZack bag and <br /> immediately placed in an ice chest containing dry ice or <br /> to a state certified <br /> frozen chemical ice far delivery storage <br /> laboratory. <br /> Sample identification, previous <br /> transportation will be conducted as outlined in the <br /> section. <br /> 1x.3 Sampling from Soil Piles or Shallow Soil fits <br /> collected and transported from <br /> Sail samples will be previous <br /> a backhoe will not be utilized. if <br /> excavated material in the manner described in will <br /> section, however, four brass cylinders <br /> les are collected,cbic yards of material to be <br /> composite ed for every regulatory <br /> be collected ecified by the lead the state <br /> sampled unless otherwise sP composited by <br /> agency. The samples will be <br /> certified analytical laboratory personnelprior to testing• <br /> 12,0 Groundwater Sampling protocol all sampling <br /> prior to arriving at the sampling site, <br /> will be washed with laboratory grade detergent, <br /> equipment water, once with acetone, and once <br /> and rinsed twice with tapThis procedure will be carried out <br /> more <br /> with deionized water. h other monitoring wells, ling <br /> on-site before a p ingto be sampled with the same same <br /> than one well <br /> device. in <br /> riot to sampling, the depth to water (DTW) <br /> immediately �' The thickness of product on top <br /> the well will be recorded•resent, will be measuised using rented <br /> of the groundwater, if p for ma <br /> interface probe. The procedure protocol) . <br /> in Section 9.0 (Groundwater Monitoring <br /> ted, analysis of groundwater at the <br /> detected, A <br /> If free product is duct will not be conducted. <br /> interface for dissolved Pro <br /> product <br /> sample will be collected for sOancintervalfspecific <br /> r all free product cannot be removed, sample from <br /> sampling device may be utilized to collect a <br /> below the zone of free product. Before collecting w least <br /> groundwater samples from each well, the well will be <br /> two g parameters <br /> (temperature, conductivity <br /> purged until indicator P The <br /> and pH) stabilize. This will entail iling the <br /> pumping. at leas <br /> four well rasing volumes by volumes and temporary <br /> criteria forSection 10-0, <br /> determining well casing (Well <br /> storage of purged water is outlined inarameter measurements <br /> Development protocol)• <br /> The indicator p of each well <br /> will be taken both before and after Purging <br />