Laserfiche WebLink
Page 50 of 59 ' <br /> NELAP Accreditation 01103C ELAP Certifica ion 1664 <br /> ENVIRONMENTAL ANALYSES <br /> NARRATIVE <br /> Lab Order: 1080911 <br /> Project ID: 08-08-1731 ' <br /> General Qualifiers and Notes <br /> Caltest authorizes this report to be reproduced only in its entirety.Results are specific to the sample(s)as ' <br /> submitted and only to the parameter(s)reported. <br /> Caltest certifies that all test results for wastewater and hazardous waste analyses meet all applicable NELAC <br /> requirements;all microbiology and drinking water testing meet applicable ELAP requirements,unless stated <br /> otherwise. ' <br /> All analyses performed by EPA Methods or Standard Methods(SM)18th Ed.except where noted. <br /> Caltest collects samples in compliance with 40 CFR,EPA Methods,Cal.Title 22,and Standard Methods. <br /> Dilution Factors(DF)reported greater than'1'have been used to adjust the result,Reporting Limit(RL),and <br /> Method Detection Limit(MDL). <br /> All Solid,sludge,and/or biosolids data is reported in Wet Weight,unless otherwise specified. <br /> Laboratory filtration for dissolved metals(excluding mercury)and/or pH analysis was not performed within the ' <br /> 15 minute holding time as specified by 40CFR 136.3 table 11. <br /> Results Qualifiers:Report fields may contain codes and non-numeric data correlating to one or more of the <br /> following definitions: ' <br /> ND-Non Detect-indicates analytical result has not been detected. <br /> RL-Reporting Limit is the quantitation limit at which the laboratory is able to detect an analyte.An analyte not <br /> detected at or above the RL is reported as ND unless otherwise noted or qualified.For analyses pertaining to ' <br /> the State Implementation Plan of the California Toxics Rule,the Caltest Reporting Limit(RL)is equivalent to <br /> the Minimum Level(ML).A standard is always run at or below the ML.Where Reporting Limits are elevated <br /> due to dilution,the ML calibration criteria has been met. <br /> J-reflects estimated analytical result value detected below the Reporting Limit(RL)and above the Method <br /> Detection Limit(MDL). The'J'flag is equivalent to the DNQ Estimated Concentration flag. <br /> E-indicates an estimated analytical result value. <br /> B-indicates the analyte has been detected in the blank associated with the sample. ' <br /> NC-means not able to be calculated for RPD or Spike Recoveries. <br /> SS-compound is a Surrogate Spike used per laboratory quality assurance manual. ' <br /> NOTE:This document represents a complete Analytical Report for the samples referenced herein and should <br /> be retained as a permanent record thereof. <br /> 9/9/2008 10:14 REPORT OF LABORATORY ANALYSIS Page 3 of 11 <br /> =ep.y This report shall not be reproduced,except in full, ' <br /> without the written consent of CALTEST ANALYTICAL LABORATORY. <br /> 1885 North Kelly Road - Napa, California 94558 <br /> (707)258-4000- Fax(707)226-1001 -e-mail: info@caltestlabs.com ' <br />