Laserfiche WebLink
11 May 2009 <br /> AGE-NC Project No. 09-1692 <br /> Page 3 of 6 <br /> Division(EHD). <br /> A Site Health and Safety Plan(SHSP)will be prepared in accordance with Occupational Safety and <br /> Health Guidance Manual for Hazardous Waste Site Activities (National Institute for Occupational <br /> Safety and Health Administration)and federal(29 CFR 1910.120)and state(Title 8,Cal.Code Reg., <br /> Section 5192)regulations. The SHSP will cover: <br /> • Health and safety officer and key personnel,andpersonnel requirements and responsibilities; <br /> • Field activities, overall work practices and standard operating procedures;. <br /> • On-site chemicals and potential hazardous substances as well as physical hazards; <br /> • Risk analysis for existing site conditions, and description of personal protective equipment <br /> to be used by personnel; <br /> • Site control measures,including work zones and security measures,and entry procedures for <br /> confined spaces; and <br /> • Exposure monitoring plan with monitoring methods, emergency response plan addressing <br /> hazardous material/waste releases, and medical surveillance requirements. <br /> All field personnel will be trained in hazardous materials communication and will have completed <br /> a 40-hour Health and Safety Course as specified in OSHA Hazardous Waste Operations and <br /> Emergency Response Standard [29 CFR 1910.120(e)], and 8-hour annual refresher courses as <br /> necessary. Prior to mobilization, the area of investigation will be clearly marked and a utility <br /> clearance obtained through Underground Service Alert. <br /> 3.2. SOIL AND GROUND WATER SAMPLE COLLECTION AND ANALYSIS <br /> AGE proposes to advance ten soil borings using direct-push technology in the location of the <br /> suspected release, around the canopy and adjacent to the product lines. Two borings will be <br /> advanced to approximately 20 feet bsg to collect soil and grab ground water samples; eight borings <br /> will be advanced to depths of 10 feet bsg to collect soil samples. Soil samples will be collected at <br /> approximate 2.5-foot intervals beginning at 2.5 feet bsg to terminal boring depth. The proposed <br /> boring locations are illustrated in Figure 2. Field procedures for advancement of borings and <br /> collection of soil and ground water samples are presented in Sections 4.1, 4.2. and 4.3. <br /> Selected ground water and soil samples will be submitted for laboratory analysis. The selected <br /> samples will be analyzed by a State of California Department of Public Health (CDPH)-certified <br /> laboratory for the following constituents: <br /> Advanced GeoEnvironmental,Inc. <br />