Laserfiche WebLink
1 <br /> TANDARD - GLOSSARY OF DATA UALIFIERS AND ABBREVIATIONS <br /> uuu kaa tE wansrwst..w <br /> Inorganic Data ualtfiers <br /> U Analyte was not detected at or above the reporting limit <br /> X Result obtained indirectly through calculation based on results from other analyses <br /> * Recovery and/or relative percent difference (RPD) are outside of advisory limits <br /> 1 <br /> OLrganic Data Qualifiers <br />' B Compound was found in the blank and the sample <br /> D Surrogate or matrix spike recoveries were not obtained because the extract was diluted for analysis <br /> E Concentration exceeds the instrument calibration range and was subsequently diluted <br />' I Appears on the "results spreadsheet" to indicate an interference <br /> J Result is an estimated value below the reporting limit or a tenatively identified compound (TIC) <br /> T Compound was found in the TCLP extraction blank and the sample <br />' U Compound was not detected at or above the reporting limit <br /> * Recovery and/or relative percent difference (RPD) are outside of advisory limits <br />' Abbreviations <br /> BS Blank Spike spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest <br />' BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit <br /> CD Calculation Factor used by the laboratory's Information Management System (CIMS) <br /> DF Dilution Factor <br /> DL Appears in the sample ID to indicate a secondary dilution was performed <br /> LCS or (LC) denotes Laboratory Control Standard <br />' MB Method Blank or (PB) preparation blank <br /> MS Matrix Spike <br /> MSD Matrix Spike Duplicate <br />' NA Not Applicable <br /> NC Not Calculated <br /> NR Not Required <br />' NS Not Spiked <br /> RE Appears in the sample ID to indicate a Re-analysis <br /> ' REP Replicate analysis <br /> REPREP Sample was reprepared and then reanalyzed <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> ' RRF Relative Response Factor <br /> RT Retention Time <br /> ' RTW Retention Time Window <br /> MOTES <br /> • One or a combination of these data qualifiers and abbreviations may appear m the analytical report <br /> • Soil sediment and sludge results are reported on a dry weight bans except when analyzed for landfill disposal or incineration <br /> parameters All other results on a solid matrix are reported on an "as received" basis unless noted differently <br /> • Reporting limits are adjusted for preparation sample size sample dilutions and sample moisture content if analyzed on a dry weight <br /> basis <br /> Revised 02/16/93 <br />