COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

T;4 I ANix LC hAN(,M L6-2464 — Aft DATE 6/20/91 SECTION=V6!!=- VIRONMENTAL---INFORMATION,' JNTINLEDJ - ---- WASTE DISPOSAL containers. Observe precautions for disposal of flammable materials. Contaminated a b s o r b a n t may be disposed in a hazardous waste landfill. Dispose only in accordance with federal, state and local regulations. 4 CLASSIFICATION This pr educt contains chromium. Waste residue of this product may qualify as hazardous waste (4C C i R Part 261.74• Characteristic of EP Toxicity). This product, if discarded directly, would be classified a hazardous waste based on its i9nitabiIity characteristic i.e. has a flash point of 140 deg. F.(60 d e 9 . C ) or less The proper R C k A classification would be D 0 0 1 This product contains lead, which, if present in waste at 5.0 mg/l or more after being extracted, is considered EP Toxicand therefore a hazardous waste under R C R A regulations. The hazardous waste number would be D 0 0 8 ENVIRONMENTAL HAZARDS None known -- -- ------ ---- --- _--- _=SGCTIONAX - I Ef3SONAC-' C3TE0fflON 1NFt�RMA3ON_ - RESPIRATORY PROTECTION Refer to OSHA standard for specific respiratory protection requirements for lead, 29CFR1910.1025 Proper selection o4respiratory protection depends upon many factors including duration/level of exposure and conditions of use In general exposure to organic chemicals such as those contained in this product may not require the use of respiratory protection if used in well ventilated areas. In restricted ventilation areas a NIOSH approved chemical cartridge respirator may be required. Under certain conditions, such as spraying, a mechanical prefilter may also be required. In confined areas use a NIOSH/ MSHA approved air supplied respirator If the TLV's listed in Section II are exceeded use a properly fitted NIOSH/MSHA approved respirator with an appropriate protection factor. Refer to OSHA 29 CFR 1910.134 "Respiratory Protection" and "Respiratory Protection A Manual And Guideline, American Industrial Hygiene Assoc." VENTILATION Refer to OSHA standards for specific ventilation requirements for Iead-29CFR1910.1025. Provide general dilution and local exhaust ventilation in sufficient volume and pattern to keep concentrations of hazardous ingredients listedin Section II below the lowest exposure limit stated. Remove decomposition products that are generated when welding, cutting, or brazing objects coated with this product Refer to "Industrial Ventilation A Manual of Recommended Practice " A C G I H . HAND PROTECTION Solvent impermeable gloves are required for repeated or prolonged contact. PROTECTION Wear safety spectactes. O 1 HER PROTECTIVE EQUIPMENT As required to prevent skin contact. See OSHA standard for lead. -$E-ODO _x= ej�' -j Q-PRECAUTIONS=__= PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Do not store above 100 deg F ( 3 8 deg.C) store large quantities in comBance with OSHA 2 9 C F R 910.106. OTHER PRECAUTIONS Do not take internally. Close container after each use. Keep away from children Do not breathe sandingg dust Wash hands and face thoroughly before eating or drinking. Empty containers must not be washed and re -used for any purpose. Containers should be grounded and bonded to the receiving container. Do not weld, braze or cut on empty container. Never use pressure to empty. Drum is not a pressure vessel. HAZARD CLASS: COMBUSTIBLE LIQUID PROPER SHIPPING NAME: P A I N T THE INFORMATION CONTAINED HEREIN IS BASED ON DATA CONSIDERED TO BE ACCURATE. WHILE THE INFORMATION IS BELIEVED TO BE RELIABLENO WARRANTY 1S EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF THIS DATA 0j THE RESULTS TO BE OBTAINED FROM TME USE THEREOF. SINCE THE USE OF THIS INFORMATION AND THE CONDITIONS AND USE OF THIS PRODUCT ARE CONTROLLED 8Y THE USERIT IS THE USER'S OBLIGATION TO DETERMINE THE CONDITIONS OF SAFE USE OF TAE PRODUCT. The Corporate Safety andEnvironmental Affairs Department is responsible for the preparation of this Material Safety Data Sheet. TRIANGLE RANCH TULANE AVENUE, SUITE ORLEANS LA 70112