Laserfiche WebLink
WEE) <br />D. Results of Testing/Servicing FEB 17 2016 <br />Software Version Installed: 327.01 <br />® Yes <br />❑ No* <br />Is the audible alarm operational? <br />® Yes <br />❑ No' <br />is the visual alarm operational? <br />® Yes <br />❑ No" <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑ No' <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br />operation? <br />® Yes <br />❑ No' <br />if alarms are relayed to a remote m onitoring station, is all communications equipment (e.g., modem) operational? <br />❑ N/A <br />® Yes <br />❑ No' <br />❑ N/A <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br />fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ® Sump/Trench <br />Sensors; ® Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks gad sensor failure/disconnection? ® Yes; ❑ No. <br />® Yes <br />❑ No' <br />❑ N/A <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br />installed), is the overfill warning alarm visible and audible the tank fill <br />at point(s) and operating properly? If so, at what percent of tank capacity <br />does the alarm trigger? 90% <br />❑ Yes ® No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name <br />and model for all replacement parts in Section E, below. <br />®Yes* ❑ No Was liquid found inside any secondary containment systems designed as dry systems? (Check a// that apply) <br />® Product; ❑ Water. If yes, describe causes in Section E, below. <br />® Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />® Yes ❑ No' is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or wlil be corrected. <br />E. Comments: <br />Monitoring System Certification Page 2 of 4 2/21/07 <br />,11111 - 4 <br />