Laserfiche WebLink
CONTACT US FOR MORE INFORMATION! <br /> 1555 Copperhill Parkway,Santa Rosa, CA 95403 <br /> Ph:707.523.2050 <br /> 3/8" Stainless Steel Test Port for DW FRP Sumff rook <br /> INSTALLATION INSTRUCTIONS ME%.;t:1VtLJ <br /> Materials Required: OCT 10 2016 <br /> Resin and Catalyst, Part # AC 1040 ENVIRONMENTAL HEALTH <br /> Fiberglass Mat, Part # AC8025 A PIT <br /> Acetone, Part # AC 1070 <br /> Grinding wheel 24 grit <br /> Shop towels or clean rags rest Port <br /> y <br /> Western Fiberglass Stainless Steel Port Fitting, Part # P10012 <br /> Bonder, Part # DWAC4500 <br /> Test Valve <br /> Purpose: <br /> This procedure is specifically for the installation of stainless steel fittings in Western <br /> Fiberglass Sumps.This procedure is to be performed by Western Fiberglass trained and <br /> certified personnel only. Only materials identified in this procedure may be used for this <br /> procedure. This procedure may be used on other manufacturer's sumps provided the <br /> materials of the sump have been identified and have been determined to be <br /> compatible with the materials used for this procedure. <br /> INSTALLATION PROCEDURE <br /> Installing the Fitting: <br /> • Mark the placement of the fittings on the sump wall. <br /> • Using a 5/16" drill, drill the spot marked for the port. Use extreme caution to only <br /> drill through the inside wall of the double wall sump. DO NOT BREACH THE OUTER <br /> WALL. <br /> • Prepare the surfaces to be glassed on the inside of the sump wall by grinding <br /> the walls to remove all foreign material and to develop a surface for the <br /> fiberglass and bonder to adhere. Clean the entire surface prepared with <br /> acetone. <br /> • Place a '/4" bead of bonder around the back side of the fitting plate, 114" inside <br /> the outer edge. <br /> ® Press the fitting onto the inside of the sump wall as marked. Use an ink pen, nail <br /> or a screw to line up the hole in the sump wall with the hole in the port. Wipe off <br /> any excess bonder to make a smooth seal. This is to provide a smooth surface <br /> for applying the glass. <br /> • Glass the stainless steel plate to the wall of the sump using catalyzed resin. Make <br /> sure to roll out the glass for a proper bond and to remove air bubbles. <br /> • Give the glass adequate time to begin to cure before testing or adding liquid to <br /> the sump. The glass must not be able to be dented by a fingernail pressed into <br /> it. <br /> Ph: 707.523.2050, Fx 707.523.2046 Page 1 of 2 <br /> sales@westernfg.com,www.westernfg.com <br />