Laserfiche WebLink
4.3 Liquid Sensor-Installation of a liquid sensor requires technician to meet applicable <br /> requirements as specified in the SWRCB Local Guidance Letter 167(LG 167). <br /> If not already present, install a liquid sensor following the manufacture's installation <br /> instructions. Set the liquid sensor two (2) inches from the bottom of the Liquid <br /> Condensate Trap.See Figure 6.Then tighten the wire grip nut(of the TSP-K2A) <br /> around sensor cable. <br /> At the point where the cable exits the top of the wire grip, place a permanent indicating <br /> mark on the sheathing of the cable (e.g. using a waterproof marker such as a <br /> Sharpi6T")which indicates the sensor is placed two(2) inches above the bottom of the <br /> Liquid Condensate Trap(see Figure 5). <br /> When programming the LCT liquid sensor at the LIST tank monitoring console, label the <br /> sensor with"LCT" in the title, e.g. L10 would be labeled "LCT High Liquid". <br /> Figure 6 <br /> Liquid Sensor Height Setting <br /> liquid Sensor <br /> Bottom <br /> oLiquid <br /> Condensate Trap <br /> Page 12 <br /> ARB Approved IOM-20-Liquid Condensate Trap Install Guide-Executive Orders VR-203-M and VR-204-M <br />