Laserfiche WebLink
E. <br /> fitbAftes <br /> r' s <br /> Attached Collar (A ) Secondary Contained <br /> This fiberglass attached collar,without flange, can Service Fittings <br /> be used to surround the fitting(s) or manway.The <br /> collar can be used with attached collar risers (as Secondary contained service fittings, typically a <br /> shown below in I&J). I.D.'s can be 42"or 48". 4"NPT within a 6"NPT, allow the tank to be <br /> Strap locations can be affected:Use of only one connected to a <br /> riser will be permitted secondary <br /> on sizes 600 thru contained <br /> 3,000 gallons. piping <br /> Maximum use ® system. <br /> of two riser <br /> will only be <br /> allowed on <br /> 4.000-6, <br /> ,000-6,dia. -or 6,000-8'dia <br /> or larger tanks. I. Grommet Kits <br /> When high water conditions <br /> Attached Collar Riser (ACR) do not exist, electrical y pi <br /> nections and secondary piping <br /> can be field installed on an <br /> This fiberglass attached attached collar riser using <br /> collar riser is intended for optional rubber grommets. <br /> use with a 42"or 48"dia- <br /> meter attached collar. Grommets are available in the following sizes: <br /> (This is sold separately. <br /> See H.) Riser body is 42" 3/4"for 3/4"O.D. electrical conduit <br /> or 48"I.D.,with a flat top ]'for 1" O.D. electrical conduit <br /> and a 22"or 32"diameter 2", 3"and 4"for 2", 3" &4"O.D. FRP pipe <br /> friction fit cover within top. ° <br /> This riser provides an en- Each kit includes six (6) grommets. <br /> closure for a submersible <br /> pump and also provides <br /> a termination point for <br /> double wall piping systems. Fiberglass lead <br /> The bonding of riser to <br /> collar is to be done by the Coupling Kit <br /> contractor. (Adhesive kits <br /> are included.) The 3" FRP coupling is a two-piece fitting that.is <br /> bonded to the attached <br /> collar riser by the contractor. <br /> J <br /> Watertight of <br /> male and female sections; <br /> of the FRP coupling are ; <br /> Attached Collar Riser (ACR ) threaded together to hold ; 1 <br /> the fitting in place while the <br /> This fiberglass watertight adhesive cures. Each kit in- " <br /> attached collar riser is in- (ZDg cludes one 3"FRP coupling, <br /> tended for use with a 42" adhesive and instructions. S <br /> or 48"diameter attached <br /> collar. (This is sold separately. Electrical Bulkhead <br /> See H.)The riser body is <br /> 42"or 48"1.D.with a Coupling Kit <br /> 26"diameter opening. <br /> This provides an en- i <br /> closure for a submersible The I"electrical coupling kit is a three-piece fitting <br /> pump and also provides a which is bonded to the ; <br /> termination point for double- attached collar riser by the <br /> wall piping systems.The contractor.The male and <br /> bonding of the riser to the female sections are threaded ° <br /> collar and the top to the riser together to hold the electrical f <br /> is done by the contractor. coupling in place while the <br /> (Adhesive kits are included.) adhesive cures. Each kit in- <br /> cludes four I"steel couplings, S <br /> adhesive and instructions. f <br /> 12 <br />