Laserfiche WebLink
toring System Certification <br /> Site Address: 3202 W HAMMER LANE Date of Testing/Service: 03/29/2005 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 16.05 <br /> Complete the following checklist: <br /> X Yes [--]No-_ Is the audible alarm operational? <br /> QYes No* Is the visual alarm operational? <br /> QYes No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Were-allsensnrs installed at lowest point of secondary containment and positioned-scLthat other equipmentwiltnot- <br /> 0_Yes DNo <br /> interfere with their proper operation? <br /> Yes No* X N/A If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> 0 Yes n No* ❑N/A monitoring system detects a leak,fails too erate,or is electrically disconnected?If yes:which sensors initiate positive <br /> shut-down?(check all that apply) XJSumplTrench Sensors; [j Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and-sensor failure/disconnection? ❑X Yes ❑No <br /> ❑X Yes E]No* NIA For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.:no mechanical g <br /> overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fillpoints(s)and operating <br /> properly? If so,at what percent of tank capacity does the alarm trigger? 95 <br /> EJYes* ❑X No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E,below. <br /> Yes* ❑X No Was liquid found inside any secondary containment systems designed as dry systems?(check all that apply) ❑Product; <br /> ❑ Water. If yes,describe causes in Section E,below. <br /> �X Yes No* Was monitoring system set-up reviewed to ensure proper settings?Attach set-up reports,if applicable. <br /> ❑X Yes No* Is all monitoring equipment operational per manufacturers'specifications? <br /> "In Section E below,describe how and when these deficiences were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 Based on CA form dated 03/01 <br />