Laserfiche WebLink
f � <br /> D.Results of Testing/Servicing <br /> Software Version Installed: 332.00 <br /> Complete the following checklist: <br /> a Yes ;, No* Is the audible alarm operational? <br /> •: Yes r No* Is the visual alarm operational? <br /> a; Yes C No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Yes CO No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with <br /> heir proper operation? <br /> •' Yes r No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> N/A <br /> Yes r, No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring <br /> N/A stem detects a leak,fails to operate,or is electrically disconnected?If yes:which sensors initiate positive shut down?(Check <br /> II that apply)W Sump/Trench Sensors; r Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection?f+ Yes; t No <br /> ? Yes No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no mechanical overfill <br /> prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly?If <br /> N/A so,at what percent of tank capacity does the alarm trigger?% <br /> • Yes* o> No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E below. <br /> • Yes* *` No as liquid found inside any secondary containment systems designed as dry systems?(Check all that apply) <br /> Product; r—Water.If yes,describe causes in Section E below. <br /> ro Yes No* as monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> +! Yes No* s all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E.Comments: <br /> t <br /> EN Of <br /> a V� t4 ), <br /> Monitoring System Certification Page 2 of 3 12/07 <br />