COMPLIANCE INFO_2010-2012 - Laserfiche WebLink

Home Browse Search

Jul 06 12 01 : 09p Elite U Contactors 12094616342 p. 5 2 System Description Visual Inspection of Console Interior in e 3. Verify that the TLS Console has a chassis ground connected. 4. Verify that power conduit and sensor and probe conduits enter TLS Console Dt y through preformed, designated knockouts. 5. Verify that probe and sensor wiring and conduit meet Veeder•Root requirement (ref.manual P/N 576013- 879). 6. If the system fails the intrinsic safety check, disconnect and cap the AC wires it the monitor,and disconnect and cap all probe and sensor field wires in the probe and sensor junction boxes . IMPORTANT! Do not apply power to the system until its installation has been c ecked and found to be in ac- cordance with the instructions outlined in the Veeder-Root TLS-3XX Series Sit( Prep and Installation manual; the National Electrical Code;federal,state,and local codes;and other applical e safety codes. Visual Inspection of Console Interior It is recommended that whenever troubleshooting,repairing,or replacing compo t( ils,a visual inspection of the overall condition of the system be made. Turn off,tag and lockout power to the console before starting this inspe c on. 1. Inspect for signs of corrosion inside the console. 2. Check for broken or frayed insulation on all wires and be sure that the wires<:re secure at their terminals. 3. Check all PC boards for cracks. 4. Check to see that there is no loose or missing hardware for components(trays )rmers, PC boards,brackets, etc.). 5. Check to see that all interconnecting cable connectors are firmly seated.Chf:c' 4.onnector ends for cracks and flat cable for breaks. 6. Check fuse continuity and fuseholder contacts for corrosion. 7. Check monitor for cracked display lens and damaged or missing buttons. 8. Check the mounting of the equipment to be sure all components were mount:=c properly and in accordance with instructions contained in the Site Preparation and Installation manual. 9. Verify that no unapproved modifications to equipment have been made, no unal :troved parts are being used, and previous repairs and modification bring the unit to original factory conditior 10.All deficiencies should be corrected and damaged components replaced befor continuing with procedures. Test Front Panel (LEDs, Display, and Console Beeper Apply power to the console.The display should read the start-up message and the .reen POWER LED should illuminate. Press the ALARM✓TEST button to verify that the red ALARM and yellow NARNING LEDs illuminate and the console beeper switches On. 2-9