Laserfiche WebLink
INSTRUCTIONS FOR COMPLETING FORM"B' <br /> GENERAL INSTRUCTIONS: <br /> 1. One FORM"B"shalt be completed for each tank for all NEW PERMITS,PERMIT CHANGES, REMOVALS and/or any <br /> other TANK INFORMATION CHANGE <br /> 2. This form should be completed by either the PERMIT APPLICANT or the LOCAL AGENCY UNDERGROUND TANK <br /> INSPECTOR <br /> 3. Please type or print clearly all requested information. <br /> 4. Use a hard point writing instrument,you are making 3 copies. <br /> TOP OF FORM."MANIC ONLY ONE I'TF.M" <br /> 1. Mark an(X) in the box next to the item that best describes the reason the form is being completed. <br /> 2. Indicate the DBA or Facility name where the tank is installed. <br /> L TANK DESCREMON-C OMPIM13 ALL ITEMS.IF UNKNOWN-SO SPECIFY <br /> A. Indicate owners tank ID#-If there is a tank number that is used by the owner to identify the tank(ex.AB70789). <br /> B. Indicate the name of the company that manufactured the tank(ex.ACME TANK MFG.). <br /> C. Indicate the year the tank was installed(ex. 1987). <br /> Q. Indicate the tank capacity in gallons(ex.25,000 or 10,000 etc.). <br /> 13. TANK CONTENTS <br /> A. 1.If MOTOR VEHICLE FUEL,check box 1 and complete items B&C <br /> 2.If not MOTOR VEHICLE FUEL,check the appropriate box in section A and complete items B&D. <br /> B. Cheek the appropriate box. <br /> C. Check the type of MOTOR VEHICLE FUEL(if box 1 is checked in A). <br /> D. Print the chemical name of the hazardous substance stored in the tank and the CA.S.#.(Chemical Abstract Service <br /> number),if box 1 is NOT checked in A- <br /> IN. TANK CONSTRUCTION-MARK ONE ITEM ONLY IN BOX A,B,C&D <br /> L Check only one item in TYPE OF SYSTEM,TANK MATERIAL,INTERIOR LINING and CORROSION PROTECTION. <br /> 2. If OTHER,print in the space provided. <br /> IV. PIPING INFORMATION <br /> 1. Circle A if above ground;circle U if underground;and circle both if applicable. <br /> 2. If UNKNOWN,circle;or if OTHER,print in space provided. <br /> 3. Indicate the LEAK DETECTION system(s)used to comply with the monitoring requirement for the piping. <br /> V. TANK LEAK DETECTION <br /> 1. Indicate the LEAK DETECTION system(s)used to comply with the monitoring requirements for the tank. <br /> VL INFORMATION ON TANK PERMANENTLY CLOSED IN PLACE <br /> 1. ESTIMATED DATE LAST USED MONTH/YEAR(January,1988 or 01/88). <br /> 2. ESTIMATED QUANTITY of HAZARDOUS SUBSTANCE remaining in the tank(in Gallons). <br /> 3. WAS TANK FILLED WITH INERT MATERIAL?Check'Yes'or'NO'. <br /> APPLICANT MUST SIGN AND DATE THE FORM AS INDICATED. <br /> INSTRUCTION FOR THE LOCAL AGENCIES <br /> The state underground storage tank identification number is composed of the two digit county number,the three digit jurisdiction <br /> number,the six digit facility number and the six digit tank number. The county and jurisdiction numbers are predetermined and <br /> can be obtained by calling the State Board(916)739-2421 The facility number must be the same as shown in form"A". The <br /> tank number may be assigned by the local agency; however,this number must be numerical and cannot contain an alphabet. If <br /> the local agency prefers the State Board to assign the tank number,please leave it blank. <br /> IT THE RESPONSIBILITY OF THE LOCAL AGENCY THAT INSPECTS THE FACILITY TO VERIFY THIN <br /> ACCURACY OF THE INFORMATION. THE LOCAL AGENCY IS RESPONSIBLE:FOR THE COMPLETION OF THE <br /> 'I.AX'AL AGENCY USE ONLY'INFORMATION BOX AND FOR FORWARDING ONE FORM'A"AND ASSOCIATED <br /> FORM-W(s)TO THE FOUDWING ADDRESS. <br /> STATE OF CALIFORNIA <br /> STATE WATER RESOURCES CONTROL BOARD <br /> C/o S.W.; jP.& <br /> DATA PROCESSING C Y94MA <br /> i_. P.O.BOX 527 <br /> PARAMOUNT,CA 907M <br />