Laserfiche WebLink
OCT 18 2002 11:06RM SS M 209 48349 p.5 <br />,� <br />AN <br />7. Can these repairs bel done if the penetration angle is greater than 15 degrees? <br />Yes. The Inservice <br />Repair Boots can seal any penetration angle. The usual culprit is the <br />conduit entry fitting sometimes with a penetration angle of 60 degrees and up. The Repair <br />Boot is attached to Cie sump wall and fitted with a plug that has been drilled with a hole <br />saw to match the pipe size and penetration angle. <br />8. Can the repairs be dne when two conduit pipes are penetrating the sump wall at odd angles <br />next to each other? <br />Absolutely. A large service Repair Boot will be used with a large plug and drilled to <br />match the off angles nd dual penetrations. <br />9. Will the Inservice Repair Boots seal polyethylene sumps? <br />Yes. Inservice Repan Boots will seal both fiberglass and polyethylene sumps provided the <br />sump wall has been roperly prepared. <br />10. Do I really need trairii <br />Yes. Factory Trainin is required to cover safety, pipe identification, entry fitting <br />identification, part ap lication, sealant delivery, pneumatic gun and equipment. When field <br />complexities are deall with through proper training, customer satisfaction will rise and job <br />orders will result. <br />11. The SSI Gun is expe*ve. Do I really need it? <br />Yes. The SSI Pneumatic Delivery Gun, G30B, is the field proven delivery tool for the 30 - <br />ounce Seal -rite cartridges. SSI has tested other guns and created our own guns and <br />delivery system thata failed miserable until the creation of the G30B. The GJOB is small <br />and compact to make ump entry fitting repairs in confined space easier and faster. <br />12. Won't a less expensiv4 gun work? <br />No. A less expensive n will not deliver the Seal -Tice at the needed PSI to setd all water <br />intrusion paths. Only a G30B, specifically designed to deliver Seal-Tite, will work for <br />SSI repairs, eliminatin installer frustration and increasing customer satisfaction. <br />13. How long before a hyciostatic test can be performed? <br />The hydrostatic test be started 90 minutes after repairs are completed. <br />