Laserfiche WebLink
Software Version Installed: Am <br />L til Rete <br />the Autluweaa-- <br />uwa.•�.•o •. <br />Yes <br />❑ No* <br />Is the audible alarm operational? <br />Yes <br />❑ No* <br />Is the visual alarm o erational? <br />Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? - <br />Were all sensors installed at lowest point of secoj ry containment and positioned so that other equipment will <br />Yes <br />❑ o* <br />not interfere with their proper operation? <br />❑ Yes <br />❑=No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to opera ,e, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) P Sump/Trench Sensors; ❑ Dispenser 96ntainment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? Yes; ❑ No. <br />❑ Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />)SPN/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill point(s) and operating properly? If so, at what, percent of tank capacity does the alarm trigger? <br />-( <br />❑ Yes* <br />No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />❑ No <br />Was liquidand inside any secondary containment systems designed as dry systems? (Check all that appl)) <br />EJProduct; Water. If yes, describe causes in Section E, below. <br />Yes <br />01 No* <br />Was monitoringsystem set-upreviewed to ensure pro per settings? Attach set a re orfs, if a licable <br />Yes <br />❑ No* <br />Is all monitoring a ui mento erational er manufacturer's s ecifications? <br />* In Section E below, describe now anci when Tnese oe11C1etltaeb wet a ut will uv — a ca acu. <br />E. Comments: <br />Pnge 2 of 3 03/01 <br />