COMPLIANCE INFO_2006-2008 - Laserfiche WebLink

Home Browse Search

Materials Tools (cont.) The following tools are recommended to install Dualoy 3000/L piping: r——————————— %-inch electric drill or equivalent air-driven motor When using pneumatic tools,the ' 4-inch hole saw for installing sump penetration fittings air supply must be dry and ' Heavy-duty heat guns,hot air blowers,heat blankets or Chem Cure Paks for cool- oil-free as moisture or oil on ; or cold-weather installation. i bonding surfaces will interfere f V/2-inch diameter by 1-inch wide coarse grit flapper sander i with the adhesive. i L-----------J Field cutting and cutting tapering primary pipe Use a fine-blade hacksaw,radial cut-off saw or circular saw with abrasive wheel to cut pipe in the field.The cut end must be square to within 3/s inch(5 mm). Hold pipe securely for all cutting and tapering.When using a pipe vise,always wrap the pipe with a protective material such as a 1/4-inch thick rubber pad as shown in Fig.5-1. Take care not to damage orover-deflect the pipe when tightening the vise. '4-Inch thick protective rubber Fiberglass pipe pad or equal • Fig.5-1.When mounting Dualoy 30001L pipe in a vise,use rubber pads or the equivalent to protect the pipe wall from crushing or abrasion. Pipe vise �• Tapering with Ameron Taper Maker Pipe ends may be tapered in 2 through 6-inch sizes using the Ameron Taper Maker. The Taper Maker employs a single carbide blade on a movable head at an angle of 13/a° to the axis of the pipe.After the blade has been adjusted to touch the pipe surface,the end is tapered by rotating the tool clockwise until the proper taper length is obtained. Cutting head I nt handle Ratchet handle screw ade retaining screws Fig.5-2. The Ameron Taper Maker is - Blade used to prepare pipe ends in 2 filet control knthrough 6-inch diameters. t Cdlet Fiberglass pipe 5