Laserfiche WebLink
INTELLIGENT CONTROLS INC http://www.intelcon.com <br />E; �C)N 74 INDUSTRIAL PARK RD SACO ME 04072 U S A <br />Replacement Parts Instructions 0000224.DOC <br />51,1111 1111111 -1 11,111:0P . � 'I I 1- 111111 111 11111 1111 • ;pIql. <br />31 "ON/OFF!— <br />Parts Required: SM TCH oN <br />1/4 Amp mini. Fuse (TSSP-F2 S1N1 8 <br />oF�F' ®? <br />J19 p4 F2 FUSE , F ®w� <br />Tools Required: to 2AG F1 ®T� <br />® ��J4 <br />1. Flat -bladed screwdrivers FUSE, F2 <br />V4A 2AG <br />(assorted sizes) FUSE, F4 <br />J7 MTT2 3A 2AG F4 <br />2. Multimeter with test probes <br />(set to read voltage at 30 VDC) O O <br />Sensor Power Fuse F2 — Removal Steps: <br />1. DANGER disconnect / turn off all electrical power going to the J4 terminal strip <br />® — Line and Relay Output power — as described in the TS -1000 Installation Manual <br />(Console and Safety Sections). <br />2. Use the multimeter and make sure NO VOLTAGE IS PRESENT between the <br />GND terminal to any other terminal at J4 and to both ends of F2. Proceed only if <br />NO VOLTAGE IS PRESENT, otherwise locate power source(s) and turn-off <br />power until no voltage is present. <br />3. Use a small flat -bladed screwdriver to pry out the old fuse <br />4. Remove the old fuse and discard. <br />1. Verify that the new fuse says 1/4 A @ 250 V (a magnifying glass may help). <br />2. Install the new fuse by pressing the fuse into the fuse clip. <br />3. Reinstall any safety -shields that were removed. <br />4. Close and lock the console door and turn the power back on. <br />Contact INCON Technical Service Department at 1-800-984-6266 for <br />troubleshooting help if the sensor fuse blows again ! <br />E-mail: tech@intelcon.com FAX 1-207-282-9002 TEL 1-800-984-6266 PAGE 1 of 1 <br />sales@intelcon.com FAX 1-207-283-0158 TEL 1-800-872-3455 <br />