COMPLIANCE INFO_2009-2015 - Laserfiche WebLink

Home Browse Search

ME . 1 9 1 1 i - ' a = • Step1. Per California SB -989, all metal must be protected from direct contact with the elements. Coat stainless steel band clamps with the following approved coatings. OPW SL -1100, 3M Underseal 08883 or Polyguard Mastic CA -9. Only the threaded hardware needs to be coated in the field. Step 2: (See Figure 1 & 2) Set riser pipe. "L" is the distance between the top of the riser pipe and finish grade. Model Series "L" Dimension 1-2100, 5 Gallon L=15" (38cm) 1-2100E, 7.5 Gallon L=21" (53cm) (Deep Bellows Model) 1-2115, 15 Gallon L=20" (51 cm) Note: For Cast Iron base, subtract 1-1/2" from Dimension "L" If using OPW FSA -400, add 3-1/4" to Dimension "L': If using OPW FSA -400-S, add 1-3/4 to Dimension Y" NOTE FSA -400-S will only work with Cast Iron Base. Step 3: Deburr and thoroughly clean riser pipe. Apply pipe dope to riser threads. Pipe dope to be a non - hardening, gasoline resistant pipe thread seal compound. Step 4: Install OPW FSA -400 Face Seal Adapter onto riser using the OPW 61 SA -TOOL. Torque to 125 ft -lbs min. to 250 ft -lbs max.(4" NPT). Apply pipe dope to FSA -400. Pipe dope to be a non -hardening, gasoline resistant pipe thread seal compound. Step 5: Install spill container by rotating the mounting ring until hand tight. NOTE: Do not attempt to completely tighten the container by using the mounting ring Step 6: Finish tightening the spill container with the OPW 61 SA -TOOL. Torque to 125 ft -lbs min. to 250 ft. Lbs. max. (4" NPT) Step 7: (See Figure 2) Apply pipe dope to nipple and install. Pipe dope to be a non -hardening, gasoline resistant pipe thread seal compound. Use only factory made nipples. Nipples must be cut square and deburred. Torque to 125 ft - lbs min. to 250 ft -lbs max. (4" NPT). Torque value is based on rotation at the center of pipe. For standard cover models install adaptor and dust cap. For sealable cover (1 SC) models, install a standard 4" pipe cap to support adjustment system. (Adaptor and dust cap must be installed in sealable cover (SC) models after concrete has dried. Note: Nipple length is determined by measuring from the bottom of the threaded portion of the base to the bottom of the cover. Then subtract 2" for clearance, height of adaptor and height of cap. Range of nipple lengths that can be used in all of the OPW spill containers: 4" minimum to 14" maximum. Figure 1 Figure 2 Finish Grade Slope 1" min. -- Dust Cap —Adaptor Nipple Bottom of - '/'thread in base Top of Riser Pipe Riser Pipe OPW 1-2100 Series Spill Container Phge,12