COMPLIANCE INFO_1986-2002 - Laserfiche WebLink

Home Browse Search

Adapters and crossovers The following adapters and crossovers shall be provided as required: Threaded adapter: bell x male Threaded adapter: bell x female Threaded adapter: spigot x male Threaded adapter: spigot x female Flanges AMENL Flanges shall be two piece (Van Stone) type provided with raised grooves on the sealing face. Fiberglass reinforced stub ends are to be adhesive bonded to the pipe or fitting. i Dimensions and tolerances Pipe dimensions Pipe shall be manufactured to steel pipe outside diameters for all sizes. Pipe outside diameter tolerances shall not exceed ±1 percent. Wall thickness The total wall thickness of pipe furnished under this specification shall not at any point be greater than 120 percent nor less than 871/2 percent of the nominal thickness. Fittings dimensions All fittings supplied under this specification shall have face-to-face dimensions and laying lengths as specified in the manufacturer's literature. Physical and mechanical ASTIVII classification property requirements Pipe shall conform to ASTM D2310 standard classification RTRP-11CX and ASTM D2996 specification designation RTRP-11 CX 5430. Minimum ASTM Property Units Value* Method Tensile strength Longitudinal 103 psi 32.5 D2105 MPa 224 Circumferential 103 psi 65.0 D1599 MPa 448 Tensile modulus Longitudinal 103 psi 2.8 D2105 GPa 19.3 Circumferential 103 psi 4.0 — GPa 27.6 Compressive strength Longitudinal 103 psi 32.5 D695 MPa 224 Compressive modulus Longitudinal 106 psi 2.8 D695 GPa 12.3 Long-term hydrostatic design basis Static 103 psi 21.0 D2992(B) MPa 145 Thermal expansion Linear 10-6in/in/°F 9.0* * D696 10-6mm/mm/°C 16.2** Stiffness Factor* * * D2412 (in) (mm) (lb•in3/int) (N•m) 2 50 45 5.1 3 80 65 7.3 4 100 55 6.2 6 150 250 28 * Based on structural wall thickness. * * Maximum value. * * * At 5% diametric deflection and room temperature Joining methods Tapered bell x spigot adhesive joints Pipe and fittings shall be joined by means of a matching tapered adhesive joint. Adhesive for joining components shall be compatible with all intended fluids. Adhesive system shall be used according to manufacturer's recommendations. Adapters and crossovers The following adapters and crossovers shall be provided as required: Threaded adapter: bell x male Threaded adapter: bell x female Threaded adapter: spigot x male Threaded adapter: spigot x female Flanges AMENL Flanges shall be two piece (Van Stone) type provided with raised grooves on the sealing face. Fiberglass reinforced stub ends are to be adhesive bonded to the pipe or fitting.