Laserfiche WebLink
13.6.2 Positioning Swivel Pipe Coupling <br />Install the appropriate size faceplate, <br />unscrew and remove the tapered <br />swage from the threaded shaft. <br />Lubricate the inside of the coupling <br />insert with metal assembly paste or <br />white lithium grease. Insert the pipe <br />coupling assembly, including the <br />ferrule over the threaded shaft and <br />seat it onto the face plate. <br />Note: Do not place ferrule on the piping. Ferrule must be <br />inserted over the insert of the coupling. <br />13.6.3 Installing The Tapered Swage <br />Thread the tapered swage onto the <br />threaded shaft until it meets the back <br />of the pipe coupling assembly. <br />NOTE: Do not use silicone based <br />lubricants. Be sure that the swivel <br />nut of the pipe coupling assembly <br />is flush against the face plate. <br />13.6.4 Inserting the Pipe <br />Insert the end of a flexible pipe section <br />inside the pipe coupling until it bottoms <br />out. Inspect the entire assembly, prior <br />to switching on the machine for the <br />following: <br />• Swivel nuts are flush against the <br />base plate. <br />• The coupling and pipe are totally <br />vertical. <br />• The ferrule is snug against the insert shoulder. <br />13.6.5 Swaging <br />To begin the swaging process, turn the <br />switch to the DOWN position. Once the <br />tapered swage passes through the <br />pipe coupling assembly, the motor will <br />turn off. Remove the coupled pipe <br />section. Turn the switch to the UP <br />position to allow the drive shaft to <br />return to the starting position. <br />13.6.6 Inspection <br />Inspect the installed pipe coupling <br />assembly inside and out to make sure - <br />there was no damage to the insert, <br />ferrule or swivel nut during the swaging <br />operation. <br />IMPORTANT. Using this <br />coupling machine with pipe <br />or couplings other than those <br />manufactured by OPW Fueling Containment Systems, <br />shall void the product warranty. <br />Note: Some flexible entry boots require at least partial <br />installation onto the pipe before coupling. When using <br />swivel couplings in direct bury applications, the studded <br />portion of a DEB -6150 and DEB -6200 must be installed <br />13 <br />e ,* <br />BY O®W FUELING CONTAINMENT SYSTEMS <br />. f� ♦ ,•'" • `� - ilk• ♦` -`;N„ i- l�iC'�j 1 <br />to be installed prior to coupling the pipe. <br />b Pipe seated <br />y in ferrule <br />Secondary <br />Jacket <br />a. Ferrule properly seated to insert shoulder. <br />b. Primary pipe pushed to the front of the ferrule inside over all <br />barbs at insert. <br />a. Notice ferrule not pushed to insert shoulder. <br />b. Piping not pushed over barbs completely. <br />13.6.7 Positioning Coax Pipe Coupling <br />Install the appropriate size faceplate, <br />unscrew and remove the tapered swage <br />from the threaded shaft. Lubricate the <br />inside of the coupling insert with metal <br />assembly paste or white lithium grease. <br />Insert the pipe coupling assembly over the <br />threaded shaft and push it down onto the <br />face plate. <br />13.6.8 Installing The Tapered Swage <br />Thread the tapered swage onto the <br />threaded shaft until it meets the back <br />of the pipe coupling assembly. <br />NOTE: Do not use silicone based <br />lubricants. Be sure that the swivel nut <br />of the pipe coupling assembly <br />is flush against the face plate. <br />