COMPLIANCE INFO_2003-2010 - Laserfiche WebLink

Home Browse Search

Page 5 of 8 7. UNDER-DISPENSER CONTAINMENT UDC TESTING Test Method Developed By: ❑Sump Manufacturer El Industry Standard ❑ Professional Engineer ❑Other(Specify) Test Method Used: ❑ Pressure ❑Vacuum El Hydrostatic ❑Other(Specify) Test Equipment Used:INCON Equipment Resolution:: +/-0.002" UDC# 1/2 UDC# 3/4 UDC # 5/6 UDC # 7/8 UDC Manufacturer: Bravo Bravo Bravo Bravo UDC Material: Steel Steel Steel Steel UDC Depth: 10" 10" 10" 10" Height from UDC Bottom to Top of Floor penetration Floor penetration Floor penetration Floor penetration Highest Piping Penetration: Height from UDC Bottom to Lowest Floor penetration Floor penetration Floor penetration Floor penetration Electrical Penetration: Condition of UDC prior to testing: D D Dry D Portion of UDC Tested' 2" above product 2" above product 2" above 2" above" product Does turbine shut down when UDC sensor detects liquid(both product ❑ Yes ❑ No O NA ❑Yes ❑ No 91 NA ❑ Yes ❑ No O NA ❑ Yes ❑ No 0 NA and water . Turbine shutdown response time N/A N/A N/A N/A Is system programmed for fail-safe i ❑ Yes ❑ No ® NA ❑Yes ❑ No El NA ❑ Yes ❑ No El NA ❑Yes ❑ No Fx1 NA shutdown?' Was fail-safe verified to be ❑ Yes ❑ No ® NA ❑ Yes ❑ No 0 NA ❑ Yes ❑ No ® NA ❑Yes ❑ No ® NA operational?* Wait time between applying pressure/vacuum/water and starting 10 min 10 min 10 min 10 m i n test Test Start Time: 12:46 pm 01:19 pm 01:19 pm 01:54 pm Initial Reading Ri): 0.009" 0.420" 0.089" 0.102" Test End Time: 01:01 pm 01:34 pm 01:34 pm 02:09 pm Final Reading(RF): 0.008" 0.419" 0.087" 0.101" Test Duration: 15 min 15 min 15 min 15 min Change in Reading RF-Ri : -0.001" -0.001" -0.002" 0.001" Pass/Fail Threshold or Criteria: +/-0.002" +/-0.002" +/-0.002" +/-0.002" Test Result: ® Pass U Fait: IM Pass D Fail Q Pass D Fait 0 Pass,❑ Fail Was sensor removed for testing? ❑ Yes ❑ No rx-1 NA ❑ Yes ❑ No E NA ❑ Yes ❑ No 0 NA ❑ Yes ❑ No O NA Was sensor properly replaced after ❑ Yes ❑ No [H] NA ❑ Yes ❑ No ❑x NA ❑ Yes ❑ No 0 NA ❑ Yes ❑ No 0 NA testing? Comments—(include information on repairs made prior to testing,and recommended follow-up for failed tests) ' If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an asterisk(*)is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160)