Laserfiche WebLink
58 SiteSentinel iTouch Controller Tank Monitoring System <br /> Installinow the jumizzl -1 <br /> Note <br /> If monitoring a normally dry well, use a meter to orient the float so the <br /> sensor is in the closed state with NO liquid present (float in lower <br /> position). If monitoring a normally wet well, use a meter to orient the float <br /> so that it is in the closed state WITH liquid present (float in upper <br /> position). <br /> This sensor requires ONE Interface Module position. <br /> • Review Figure 21 on page 61. <br /> • Use Table 9 below to connect the sensor to the Controller I.S. Interface Module <br /> terminals. <br /> • Use the supplied cable gland and silicon wire nuts. <br /> • Install seal-offs at both ends of the conduit run <br /> Connections <br /> I.S. Interface Module Position Sensor Wire <br /> +12 Red <br /> J—Lf-L Black <br /> _L I No connection <br /> Table 10:Single-Level Sump Sensor Wiring <br /> a(14109 <br /> Sensors:30-3221-1 Single-Level Sump Sensor <br />