Laserfiche WebLink
D. Results of Testing/Servic b <br /> Software Version Installed: s <br /> Complete the following checklist: <br /> es ❑ No* Is the audible alarm operational? <br /> es ❑ No* Is the visual alarm operational? <br /> Ye ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper,operation? <br /> ❑ Yes ❑3 N-o*— If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> 1.7� N/A operational? <br /> es ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak,fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ump/Trench Sensors; Ispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? es; No. <br /> ❑ Yes ❑ N * For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> /A mechanical overfill prevention.valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes* UrNo Was any monitoring equipment replaced? If yes,identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yes* o Was liquid found inside any secondary containment systems designed as dry systems? (Check all that appl)) <br /> El Product; El Water. If yes, describe causes.in Section E,below. <br /> 13 No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br />