Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 123.01 <br />Comnlete the following checklist: <br />F Yes <br />r No* <br />Is the audible alarm operational? <br />Yes <br />r No* <br />Is the visual alarm operational? <br />Yes <br />r No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />r Yes <br />r No*Were <br />all sensors installed at lowest point of secondary containment and positioned so that other equipment <br />will not interfere with their <br />o r operation? <br />* Yes <br />r No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />F N/A <br />operational? <br />Yes <br />r No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary <br />F N/A <br />containment monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which <br />sensors initiate positive shut -down? (Check all that apply) <br />F Sump/Trench Sensors; r Dispenser Containment Sensors. Di d you confirm positive shut -down <br />due to leaks and sensor failure/disconnection? <br />r Yes; F No. <br />Yes <br />F No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />F N/A <br />mechanical overfill prevention valve i s installed), is the overfill warning alarm vi Bible and audible at the <br />tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? <br />• Yes* <br />F No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment <br />relaced and list the manufacturer name and model for all replacement parts in Section E, below. <br />r Yes* <br />F No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that <br />apply) F Product; F Water. If yes, describe causes in Section E, below. <br />r Yes <br />F No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />F No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />*In Section below, describe how and when these deficiencies were or will be corrected <br />E. Comments: <br />sensors from page 1: <br />Middle Sump: 794380-208/ Certified <br />Supply Trans. Box: 794380-208/ Certified <br />(L6) Vent Box: 794380-208/ Certified <br />(L7) Pump Pan Box: 794380-208/ Certified <br />tube is equipped with an overfill prevention valve. <br />