COMPLIANCE INFO_2010-2012 - Laserfiche WebLink

Home Browse Search

SWRCB, January 2002 Page 5 of 5 8. FILL RISER CONTAINMENT SUMP TESTING Facility is Not Equipped With Fill Riser Containment Sumps ❑ Fill Riser Containment Sumps are Present, but were Not Tested ❑ Test Method Developed by ❑ Sump Manufacturer ® Industry Standard ❑ Professional Engineer ❑ Other (Specify) Test Method Used ❑ Pressure ❑ Vacuum N Hydrostatic ❑ Other (Specify) Test Equipment Used: Incon TS -STS Equipment solution: .0006 Fill Sump # Middle Fill Sump # Fill Sump # Fill Sump # UE042U001 �UE042UO01 Sump Diameter: 38" 38" Sump Depth: 41" 40.5" Height from Tank Top to Top of Highest Piping Penetration: N/A 10" Height from Tank Top to Lowest Electrical Penetration: 14" 8" Condition of sump prior to testing: Good Good Portion of Sump Tested: 2" Above Collar Sump Material: Fiberglass Fiberglass Wait time between applying pressure/vacuum/water and starting test: 15 Min Test Start Time: 10:20 AM 10:36 AM Initial Reading Ri): 2.9936 2.9938 Test End Time: 10:35 AM 10:51 AM Final Reading (Rf): 2.9937 2.9935 Test Duration: 15 Min 15 Min Change in Reading Rf-Ri : .0001 .0003 Pass/Fail Threshold or Criteria: .002 .002 Test Result: N Pass ❑ Fail ❑ Pass N Fail ❑ Pass ❑ Fail ❑ Pass ❑ Fail Is there a sensor in the sump? N Yes ❑ No N Yes ❑ No ❑ Yes ❑ No ❑ Yes ❑ No Does the sensor alarm when either roduct or water is detected? ❑ Yes N No ❑ NA ❑ Yes N No ❑ NA ❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA Was sensor removed for testing? N Yes ❑ No ❑ NA ❑ Yes N No ❑ NA ❑ Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA Was sensor properly replaced and verified functional after testing? ❑ Yes N No ❑ NA 11 ❑ Yes N No ❑ NA ❑ Yes ❑ No ❑ NA 1 ❑ Yes ❑ No ❑ NA Comments include any information on repairs made prior to testing,and recommended follow-up for failed tests The Middle Sump sensor were reinstalled to the lowest point, but not tested. The Fill Sump is a visual failure due to the Vent Secondary cracked test boot. Did not put any test water into the fill sump.