Laserfiche WebLink
0 .0 <br />D. Results of Testing/Servicing <br />Software Version Installed: 11G.–GO <br />Cmmnlete the following checklist: <br />Yes ❑ No* <br />Is the audible alarm one ational? <br />Yes ❑ No* <br />Is the visual alarm o erational? <br />Yes ❑ No* <br />Were all sensors visual] ictionally tested, and confirmed operational? <br />❑ Yes No* <br />Were all sensors installed at.lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation. <br />® Yes ❑ No <br />If alarms are relayed to a remote monitoring station,. is all communications equipment (e.g. modern) <br />N/A <br />operational? <br />Yes ❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) O(Sump/Trench Sensors; % Dispenser Containment Sensors. <br />Did ou confirm positive shut -down due to leaks and sensor failure/disconnection? Qr Yes, ❑ No. <br />❑ Yes ❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />tj N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill oint(s) and o ratinproperly? If so, at what percent of tank capacity does the alarm trier? <br />If identify specific sensors, probes, or other equipment replaced <br />❑ Yes* No <br />Was any monitoring equipment replaced? yes, <br />and list.the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* No <br />Was, liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />Yes ❑ No* <br />Was monitoring system set-up reviewed to ensure proper se.ttin s? Attach set u reports, if applicable <br />Yes ❑ No* <br />Is all monitorin ui mentoperational r manufacturer's specifications? <br />*in Section E below, describe how and when these oen ienci- —j-1 .,, <br />Page 2 of 03/01 <br />