Laserfiche WebLink
JIECEIVED <br />FEB 0 6 2017 <br />ENVIRONMENTAL HEALTH <br />tole L. <br />LMI Lo <br />This manual contains installation procedures for the replacement of all interstitial liquid sensors for steel tanks in an <br />existing TLS monitoring system designed and manufactured by Veeder-Root. <br />This manual assumes field wiring has been run from the console to the tank in which this sensor will be installed <br />following instructions in the appropriate console's site prep manual. <br />Contractor Certification Requirements <br />Veeder-Root requires the following minimum training certifications for contractors who will install and setup the <br />equipment discussed in this manual: <br />Installer (Level 1) Certification: Contractors holding valid Installer Certification are approved to perform wiring <br />and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless <br />equipment installation; tank and line preparation; and line leak detector installation. <br />ATG Technician (Level 2/3 or 4) Certification: Contractors holding valid ATG Technician Certifications are <br />approved to perform installation checkout, startup, programming and operations training, system tests, <br />troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. <br />In addition, Contractors with the following sub -certification designations are approved to perform installation <br />checkout, startup, programming, system tests, troubleshooting, service techniques and operations training on the <br />designated system. <br />• Wireless 2 <br />• Tall Tank <br />Warranty Registrations may only be submitted by selected Distributors. <br />Product Marking Information <br />RELATED DOCUMENTS <br />Documents Required to Install Equipment <br />This intrinsically safe apparatus is only for use as part of a Veeder-Root Automatic Tank Gauging System (ATG <br />Console with probes and sensors). To install intrinsically safe apparatus, use the specific control drawing that <br />appears on the nameplate of the applicable associated apparatus (ATG Console): <br />Equipment <br />UL/cUL Control Drawing <br />Document No. <br />Associated Apparatus <br />TLS -450/8600 <br />331940-008 <br />TLS -350, TLS -350R <br />331940-011 <br />TLS -300 <br />331940-013 <br />TLS4/8601 <br />331940-018 <br />TLS -X6/8603 <br />331940-020 <br />The control drawings contain information related to the correct installation of the overall intrinsically Safe System. <br />This includes information such as maximum number of apparatus, specific apparatus allowed in the system, <br />maximum cable lengths, references to codes, proper grounding and so on. Control drawings can be found on the <br />