Laserfiche WebLink
Icon Repair • Design <br /> Filled*IRIFTCI*.*F" Non-Split RepairPart Numbers <br /> STEP 7 Apply the repair d the threads of the fitting <br /> cuff, <br /> and thread or"popsealant ir <br /> boot onto the threaded cuff. <br /> STEP 8 Index or rotate the repair boot so that the vent tube is at the iz:oo <br /> position. <br /> STEP 9 Apply FastFuse glue on the insert and in the mouth of the repair <br /> boot where they make contact and push the insert into the boot <br /> There is no need for any cure time as previously required for the <br /> split boot bonding process. Keep moving forward with the <br /> process. <br /> fAir <br /> EA L <br /> STEP io Install the band clamps and tighten securely. Fill the entire boot <br /> cavity through one of the tubes with a filler material,like FastFill, <br /> until the material begins to come out of the vent tube. Allow for <br /> some gravity and settling to occur and then add any additional filler <br /> as necessary. <br /> STEP Clean up any excess sealant in preparation for any testing that may <br /> follow.When completed,you may immediately start any <br /> hydrostatic testing to confirm a successfid repair. The fill and <br /> sealant may not yet be completely cured,but there is sufficient cure <br /> at this point that testing is feasible. There is no requirement to <br /> wait any longer if done properly. The quickly gelled nature of the <br /> sealants and fillers allows for testing immediately afterwards. <br /> 855.379.7867 855.37• : • • A,i c•n ta i n ni e n t.co ni i co n t a i n ni e n t.c•ni <br />