Laserfiche WebLink
D. Results of Testing/Servicing <br /> y <br /> Software Version Installed: <br /> —Complete the following checklist: <br /> 99 Yes ❑ No* Is the audible alarm operational? <br /> Yes ❑ No* Is the visual alarm operational? <br /> JA Yes ❑ No* Were all sensors visually inspected, functionally tested,and confirmed operational? <br /> JU Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ® No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> A N/A operational? <br /> ❑ Yes LK No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ❑Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑Yes; ❑No. <br /> ❑ Yes ❑ .No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> M N/A mechanical overfill prevention valve is installed), is the overfill warning"alarm visible and audible at the tank <br /> r,C46le fill oint(s)and o eratin ro erl ? If so,at what ercent of tank ca aci does the alarm tri er?Si No Was any monitoring equipment replaced? If yes,identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all relacement arts in Section E,below. <br /> A No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> Product; ❑Water. If yes,describe causes in Section E,below. <br /> J&Yes ❑ No* Was monitoring stem set-up reviewed to ensure pLoper settings?Attach set up reports,if applicable <br /> Yes ❑ No* Is all monitorin a ui mento erational er manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will.be corrected. <br /> E. Comments: $'iTc o14S 4Mmt_ u�f lEs?'�N�i ��+n�0uG7ED <br /> Page 2 of 3 03/01 <br />