COMPLIANCE INFO_2007-2009 - Laserfiche WebLink

Home Browse Search

Page 10 of 14 14. UNDER-DISPENSER CONTAINMENT UDC TESTING Test Method Developed By: ❑UDC Manufacturer I] Industry Standard ❑Professional Engineer ❑Other(Specify) Test Method Used: ❑Pressure ❑Vacuum El Hydrostatic ❑ Other(Specify) Test Equipment Used: Lake Test Equipment Resolution: UDC# 13-14a UDC # 14-15a UDC # 15-16a UDC# 16-17a UDC Manufacturer: Bravo Bravo Bravo Bravo UDC Material: Steel Steel Steel Steel UDC Depth: Height from UDC Bottom to Top of 0 0 0 0 Highest Piping Penetration: Height from UDC Bottom to Lowest 0 0 0 0 Electrical Penetration: Condition of UDC prior to testing: Dry Dry Dry Dry Portion of UDC Tested' 2" above product 2" above product 2" above product 2" above product Does turbine shut down when UDC sensor detects liquid(both product ❑ Yes ❑ No IRI NA ❑ Yes ❑ No ® NA ❑Yes ❑ No ® NA ❑Yes ❑ No IM NA and water)?* Turbine shutdown response time See comment Is system programmed for fail-safe ❑ Yes ❑ No ® NA ❑Yes ❑ No ❑ NA ❑Yes ❑ No ❑ NA ❑Yes ❑ No ❑ NA shutdown?' Was fail-safe verified to be ❑ Yes ❑ No IRI NA ❑Yes ❑ No ❑ NA ❑Yes ❑ No ❑ NA ❑Yes ❑ No ❑ NA operational?* Wait time between applying pressure/vacuum/water and starting 5 min 5 min 5 min 5 min test Test Start Time: 4:00 PM 4:00 PM 4:00 PM 4:00 PM Initial Reading(Ri): 7 1/2" 7" 7" 73/8- Test 3/8"Test End Time: 5:00 PM 5:00 PM 5:00 PM 5:00 PM Final Reading(RF): 7 1/2" 7" 7" 7 3/8" Test Duration: 1 hr 1 hr 1 hr 1 hr Change in Reading(RF-Ri): 0 0 0 0 Pass/Fail Threshold or Criteria: 1/16 hr 1/16 hr 1/16 hr 1/16 hr Test Result: 0 Pass ❑ Fain ® Pass ❑ Fail ® Pass ❑ Fail rx1 Pass ❑ Fail Was sensor removed for testing? ❑ Yes ❑ No IXI NA ❑ Yes ❑ No ® NA ❑Yes ❑ No ® NA ❑ Yes 0 No IRI NA Was sensor properly replaced after ❑ Yes ❑ No ® NA ❑ Yes ❑ No ® NA ❑Yes ❑ No ® NA ❑ Yes ❑ No ® NA testing? Comments—(include information on repairs made prior to testing,and recommended follow-up for failed tests) Turbine shut down during Annual monitor certification. ' If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an asterisk(*)is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160)