COMPLIANCE INFO_2010-2018 - Laserfiche WebLink

Home Browse Search

MONITORING SYSTEM CERTIFICATION CERTIFICATION /TEST DATE: September 17, 2018 Al. FACILITY A2. OWNER Name Teichert Mobile Equipment Name Teichert Construction Address 120 Frank Circle , Stockton, CA 95206 Address P.O. Box 15002, Sacramento, CA 95851 Phone # 916=366-8631 Phone # 916-386-3767 Contact Steve Schamaun III Contact Steve Schamaun D. RESULTS OF TESTING / SERVICING Make /Model of Monitoring System: Veeder-Root TLS -350 Software Version Installed: 328.03 Complete the following checklist: SN# ■ Yes ❑ No* Is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? ■ Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ■ Yes ❑ No* if alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modems) ❑ NIA operational? ■ Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ■ Dispenser Containment Sensors. ■ Yes ❑ No * Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ■ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? 90% ❑ Yes * ■ No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ■ Yes * ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ■ Water. If yes, describe causes in Section E, below. ■ Yes ❑ No* Was monitoring system set-up reviewed to insure proper settings? Attach set-up reports, if applicable. ■ Yes ❑ No * Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Removed a small amount of water from the Waste Oil fill sum Page 2 of 3