COMPLIANCE INFO_2000-2009 - Laserfiche WebLink

Home Browse Search

Monitoring System Certification - "0 of 3 1:1 Site Address: 1330 E. Yosemite @ Highway 99 Date of Testing/Servicing D. Results of Testing / Servicing Software Version Installed- 0 thn fnnnwina rhr oltlict^ 02/26/02 ® Yes ❑ No* Is the audible alarm operational? ® Yes ❑ No* Is the visual alarm operational? ® Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) 99 N/A operational? ® Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes ❑ No ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? 0 % ❑ Yes* IN No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ® Yes* ❑ No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ❑ Water. If yes, describe causes in Section E, below. ® Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings? Attach set-up reports, if applicable ❑Yes ®No* Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will be corrected. E. Comments: Need to movereg, prem and diesel fill sump sensor to lowest point in sump. Diesel Sump sensor needs to be moved to other side of sump. Dispenser pan sensor on #9-10 bad. 3/13/02 - Removed water from fill sumps. Left barrel at site. Relocated all three fill sump sensors to lowest point in sump and relocated prem and diesel stp sump sensor to correct location in sump. Replaced dispenser pan on #9-10, all tested O.K. Premium and diesel share the annular sensor