Laserfiche WebLink
D. Results of Testing/Servicing <br /> e <br /> Software Version Installed: I `� <br /> C mplete the following checklist: <br /> Yes ❑ No* I Is the audible alarm operational? <br /> Yes I ❑ No* I Is the visual alarm operational? <br /> Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment wil <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ * If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem' <br /> N/A operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> Cl N/A monitoring system detects a leak, fails to operate or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ump/Trench Sensors;. C3 Dispenser C ntainment Sensors. <br /> Did you confirm positive shut-down due to Ieaks and sensor failure/disconnection?',! Yes; E3 No. <br /> r <br /> Yes I ❑ o* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> Cl Yes* NoLIs <br /> as liquid found inside any secondary containment systems designed as dry systems? (Check all that appl)) <br /> Product; ❑Water. If yes, describe causes.in Section E,below. <br /> O/Yes ❑ No* as monitoring system set-up reviewed to ensure proper settings?.Attach setup reports,if applicable <br /> Yes ❑ No* all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below, describe how and when these deficiencies were'or will be corrected. <br /> E. Comments: <br />