ARCHIVED REPORTS_XR0009302 - Laserfiche WebLink

Home Browse Search

Macro-CorAoi I Sampler — CloseAiston Operation Sampling Procedure l !t 1 Connect a drive cap to the drive head at the top end of the sampler } t Figure 4 Tightening 2 Assemble parts of the MC locking piston (Figure 2) bolt inside cutting Insert locking piston into cutting shoe (Figure 3) and a shoe with combina- tighten bolt with NIC combination wrench (Figure 4) tion wrench It using the MC Core Catcher, attach core catcher to c Cutting shoe, cup side away from cutting shoe Trim ¢ approximately 0 4 in 00 2 mm) trom the end of a MC PETG or Teflon liner then slide liner over core catcher h cup side Ill, onto cutting shoe (Figure 5) (Do not trim fr .x sample liner when used without core catcher ) It core catcher is not used attach cutting shoe assembly to sample liner r Figure 5 Sliding liner over core catcher and vcutting shoe 3 Insert liner into sample tube (Figure 6) and securely tighten the cutting shoe to the sample tube (Figure 7) 4 When working vtiith the smaller size Geoprobe machines (Models 4200, 4220 or 420U), raise the probe shell to the highest position then raise the toot oft the surtace to allow room to place the sampler below the hammer Raising the probe toot is not necessary when working Figure 6 Inserting «ith Models 5400 or 5400 Be sure to keep the derrick liner inside Macro- vertical Place MC sampler in vertical position under = Core sample tube hammer The MC sampler should always be positioned parallel to the axis of the probe machine derrick <a` 5 Place the sampler in the driving position (Figure 8) Raise the hammer latch into the "up" position while 3A initially driving the sampler to avoid contact with the drive head Figure 7 Cutting shoe with drive point is securely tightened onto sample tube mar Figure 8 MC sampler in driving position The Tools for Site Investigation bO°aao0-k aL}��a� �°� oOa�� a.¢ �ao� � oho •oa,a`d fiF °aA .o .� B.7