FIELD DOCUMENTS - Laserfiche WebLink

Home Browse Search

STANDARD FIELD PROCEDURES FOR MONITORING WELL DESTRUCTION This document presents standard field methods for properly destroying groundwater monitoring wells. The objective of well destruction is to.destroy wells in a manner that i§ protective of potential water resources. -The two procedures most commonly used are pressure grouting and drilling out the well. These procedures are designed to comply with Federal, State and 'local regulatory guidelines. Specific field procedures are summarized below. Pressure Grouting Pressure grouting consists of injecting neat Portland cement through a tremie.pipe under �I pressure to the bottom of the well. The cement is composed of about five gallons of water to a 94 pound. sack of Portland I/Il Cement. Once the well casing is full of grout, it is pressurized for five minutes by applying.a pressure of 25 pounds per square inch (psi) with a grout pump, The well casing can also be pressurized by extending the well casing to the appropriate height and filling it with grout. In either case, the additional pressure allows the grout to be forced'into the sand pack. After grouting the sand pack and �! casing,the well vault is removed and the area resurfaced or backfilled as required. -Well Drill Out When well drill out is required, the well location is cleared for subsurface utilities and a } hollow-stern auger (or other appropriate) drilling rig is used to drill out the well casing and filter pack materials. First, drill rods are placed down the well and used to guide the . augers as they drill out the well. A guide auger is used in .place of the drill rods if feasible. Once the well is drilled out, the boring is filled.with Portland cement injected through the augers or a tremie pipe under pressure to the bottom of the boring. The well vault is removed and the area resurfaced or backfilled as required. i, " I M