Laserfiche WebLink
' k'q KLEINFELDER <br /> 2 The leachate elevation is then measured from a set location using a conductivity-based <br /> water-level meter The level is generally measured from a surveyed mark on the north <br /> rim of the casing <br /> 3 A leachate sample is then collected using a clean, disposable bailer <br /> 4 The sample is labeled and immediately stored in an iced cooler pending transport to the <br /> analytical laboratory The sample is logged on a chain-of-custody <br />' A-7 SURFACE WATER MONITORING <br />' i Prior to collecting surface water samples, the depth of water is estimated at a designated <br /> location in the surface water body <br />' 2 Surface water samples are collected directly from the stream or surface water using a <br /> clean unpreserved plastic bottle, disposable bailer, bailer, coliwasa, DipstikTM, dipper, <br /> peristaltic pump, etc , or by directly filling the sample containers Sampling equipment <br /> will either be disposable, dedicated or decontaminated in accordance with the above- <br /> defined decontamination protocols <br /> 3 Care is taken not to disturb the stream bottom and introduce sediment in the sample The <br /> fluid is then poured into appropriate preserved or unpreserved bottles for the requested <br /> analysis <br /> 4 The sample is labeled and immediately stored in an iced cooler pending transport to the <br /> analytical laboratory The sample is logged on a chain-of-cu stody <br /> ' A-8 TANK REMOVAL SAMPLING <br /> A-8.1 Collection of Soil Samples and Laboratory Analysis <br /> ' Soil and water samples will be collected during the tank removal operations in accordance with <br /> the current Leaking Underground Fuel Tank Field (LUFT) Manual and the Tri-Regional <br /> ' Guidelines issued by the California Regional Water Quality Control Board (RWQCB) <br /> A Kleinfelder, environmental geologist will be on site during the tank removal activities to <br /> ' collect soil samples for qualitative field screening and laboratory analysis Tank Excavation soil <br /> samples will be obtained by scraping the sidewalls or excavation bottom at the desired locations <br /> with the backhoe bucket Samples will then be collected from the bucket by packing soil in a <br /> ' clean brass tube with a clean hand trowel The soil samples may also be collected using a slide <br /> hammer lined with a clean brass tube with appropriate extension to reach the desired sampling <br /> depth The collected brass tubes will then be sealed with Teflon sheets and tight fitting plastic <br /> ' caps <br /> ' 28209 T03/ T03RI312 Page A-7 <br /> S <br /> 1121103 Kleinfelder, Inc September 22,2003 <br />