ARCHIVED REPORTS_XR0007456 CASE 1

Home Browse Search

' k%j KLEINFELDEP. 3 Water level measurements are made using a conductivity-based water-level meter Depth-to-water is generally measured from a surveyed marls on the north rim of the PVC well casing The water level measurements are converted to elevations using the surveyed casing elevations B-4.2 Groundwater Samplin ' Groundwater samples are collected from the monitoring wells at the site The sampling protocol for each well is as follows I Down-well equipment (pumps, bailers, etc ) is decontaminated by steam cleaning, or by scrubbing in a trisodium-phosphate or non-phosphate detergent wash followed by a distilled water rinse, prior to use in each well Bailer cord is replaced prior to use in each well 2 The depth to groundwater is measured using a conductivity-based water-level meter 3 The volume of water in gallons standing in the well is calculated by subtracting the depth to groundwater measurement from the depth of the well and multiplying by the appropriate conversion factor (0 16 for 2-inch wells, and 0 65 for 4-inch wells) 4 Three to five well volumes of water are purged from each well using a submersible pump, bladder pump, or Teflon bailer 5 Physical parameters (pH, electrical conductivity, and temperature) are monitored for ' stability while purging The physical parameter measurements are recorded on purge- and-sample logs, along with the time and volurne of water purged at each measurement ' 6 Samples are collected with a disposable bailer or bladder pump into appropriately prepared bottles provided by the analytical laboratory 7 Samples for metals analysis are usually filtered in the field at the time of collection 8 Samples are immediately labeled and placed in an iced sample container At the end of the day, the samples are delivered to the analytical laboratory under chain-of-custody control i ' 20-141746 E01/2019R338 Page B-6 01999 Kleinfelder, Iris MaN 12 1999