Laserfiche WebLink
2.0 METHODS AND PROCEDURES <br />' 2.1 GROUND WATER LEVEL MEASUREMENT <br /> Depth to ground water was measured In all wells using an electronic well sounder on <br />' December 22, 1993. <br /> 2.2 GROUND WATER NAMPLINQ <br /> Following the depth to water measurements, approximately four well-casing volumes of <br /> ground water was purged from each well using an electric submersible pump. The purge <br /> water was stored In DOT-approved drums pending analysis and proper disposal. Ground <br />' water samples were collected from wells MW-1 through MW-4 using new disposable <br /> polyethylene bailers lowered Into each well with new nylon cord A duplicate sample was <br /> also collected from well MW-4 for quality control purposes. The samples were decanted <br /> from the bailers into 40-milliliter clear glass vials containing a trace amount of hydrochloric <br /> acid (used as a preservative) and 1-liter amber bottles. The samples were Immediately <br /> labeled and placed on Ice, along with a laboratory supplied trip blank, consisting of <br /> ' denomzed water, for transport under chain of custody to the laboratory. Ground water <br /> sampling data forms are included as Appendix A. <br /> All water samples were submitted to Curtis and Tompkins, Ltd (C&T) of Berkeley, <br /> California, a state-certified laboratory, for analysis of TPH-D and BTEX by EPA Methods <br /> 8015 modified and 8020. The trip blank was submitted with the samples; however, It was <br /> ' lost by the laboratory and could not be analyzed. <br /> Environmental Science <br /> F\69351$6\4gmr 93 4 &.Engineenng,Inc <br />